Assembly Procedures - Vevor Rc-1803H Bedienungsanleitung

1. Assembly Procedures

1
Assemble parts A, C, S and R (do not reverse the direction of part C as shown in
the figure), and tighten all screws using tools such as a 13 mm wrench and a
5mm Allen wrench.
2
3
Install part E into the
component in step 1,as
shown in the figure and
align the empty hole
positions. Take parts Kx1,
Ox1, Rx1, and Px2 for
assembly and tighten the
screws. After completion,
install the knob F.
Note: Before installation,
open the safety buckle of
K.
After aligning the installation
holes of G and I as shown in
the figure, take parts Kx1,
Mx1, Px1, and Nx2 for
assembly and tightening of
screws. After completion, take
B and D for installation and
tightening.
Note: Before installation,
open the safety buckle of K
first.
9