Wall Mount; Care; Important Note - STIEBEL ELTRON FFB 1 SL Electronic Comfort Bedienungs Und Installationsanleitung Handbuch

simultaneous transmission may cause a fault
in the line-of-sight radio link to the instanta-
neous water heater. No risk is involved, i.e. the
set temperature cannot be changed uninten-
tionally, but the set temperature transmitted
will not be recognized by the receiver. In these
cases the temperature setting will have to be
repeated.

1.3 Wall mount

If required by the user, the wall mount sup-
plied can be fitted in any location to hold the
radio remote control unit. It can be fitted with
the adhesive pad supplied or with screws.

1.4 Care

A damp cloth is all that is needed to care for
the parts. Do not use any abrasive or solvent-
type cleaning agents.
12

1.5 Important note

The CE marking on the FFB..SL radio remote
control registers compliance with the basic
requirements
– according to the law on radio systems and
telecommunication equipment (FTEG) and
Directive 1999/5/EG (R&TTE);
– according to the Low Voltage Directive
2006/95/EG;
– according to the EMC Directive 2004/108/EG.
Keep these instructions safe and if
the water heater changes hands give
to the new owner. If any servicing work is
performed, the instructions should be given
to the qualified installer to read.
Installation of the transceiver module and/or
first start-up of the FFB 1 SL must be perfor-
med by a qualified installer in accordance with
these installation instructions.
To establish a connection between the instan-
taneous water heater and the radio remote
control unit  , the FFB 1 SL's transceiver
module  must be installed first.
If the instantaneous water heater is to be ope-
rated from several radio remote control units,
up to 5 further FFB 2 SL radio remote control
units can be logged into the transceiver modu-
le installed.