VEVOR 10L-V1 Benutzerhandbuch Seite 11

press [Trig] again.
Note: The trigger value is set to < empty bottle weight.In automatic mode,
the automatic filling is triggered when the weight of the empty bottle
exceeds the trigger value.
3, "Manual mode" operation method: (Press the [Man] key, the manual light
is on, enter the manual mode;)
(1) Put the empty bottle, press the [Tare] button to remove the empty bottle
weight, press the [Run] button to start the filling.The weight of the poured
liquid reaches the set filling weight and stops automatically.
(2) Remove the filled bottle, put down an empty bottle, and press the [Tare]
[Run] button to start the next filling.
4，"Automatic mode" operation method: (Press the [Auto] key, the
automatic light is on, enter the automatic mode)
Put the empty bottle, and the system automatically peels and automatically
starts filling after a delay of x seconds. When the weight reaches the filling
weight, the filling is automatically stopped.Remove the filled bottle and the
system will automatically reset to zero after a delay of x seconds.Put the
next empty bottle and automatically start the next filling.
Note: When using the automatic mode, if the machine is not properly filled,
it is because of a mistake caused by a cycle not end yet.At this point,
remove the bottle and press [Tare] to use it normally.
5，The setting method of "storing 4 groups of filling weights to M1-M4":
Press the [Save] key (the number of filling weights starts to flash), input the
value to be stored, and finally press the [M1] key (the number of"filling
weight" stops flashing) and the number to be entered is stored in M1.
When you need to use the value of ml as the filling weight, you can press
m1 to set the value of m1 as the filling weight. (Set M2, M3, M4 as the
method of setting M1)
6，How to cancel the automatic peeling function :
Restart the machine, press the [Auto] button, and then hold down the [3]
button until you hear the alarm sound of the machine and let go. At this
time, the automatic peeling function has been canceled.
If you want to turn on the automatic peeling function, repeat the above
operation. Once set up, the machine will remember forever.
- 9 -