Atf Exchange - Autool Atf702 Benutzerhandbuch

ATF ●
exchange
●
●
●
●
you can observe the oil flow from the new and old oil windows. During the
cleaning process, switch between each gear and pause for 5-10 sec-
onds, completing the cleaning in 5 minutes, after which you can turn off
the engine.
Turn the left valve to the "Exchanging" position and the right valve to the
"Exchanging" position. Turn on the machine's power switch, and start
injecting new oil into the transmission. When oil is seen flowing in the new
oil window, start the car's engine, and the automatic transmission will
begin the oil change.
During the oil exchange process, observe the new and old oil windows. If
the flow rate of the new oil is slower than the old oil, use the valve on the
return oil pipe to reduce the flow of old oil, to balance the flow rates of the
new and old oils.
During the exchange of new and old oil, each gear should be held for 5-10
seconds.
Watch the color change in the old oil window. When the color of the trans-
mission fluid in the old oil window changes from murky to the same color
as the new oil, the transmission oil change is complete.
Turn off the car's engine, restore the transmission oil pipe connection as
it was, then restart the engine and switch to "P" (Park) to check the trans-
mission fluid level. If the fluid level is low, add more new transmission fluid
and check for any leaks in the pipes. After the fluid level is sufficient, test
drive for about a kilometer, then check again (very important).
NOTE
Ensure correct connection of the drainage pipe, return pipe, and automat-
ic transmission oil pipe.
Check for any leaks in the connections. If there are any leaks, stop the
machine and reinstall.
10