Preparation Before Operation; Adding Transmission Fluid; Operating Steps; Cycle Cleaning - Autool Atf702 Benutzerhandbuch

PREPARATION BEFORE OPERATION

Method 1
Adding
transmission
●
fluid
Method 2
●
Connect the battery clamps to the car's battery (red clamp to the posi-
tive terminal, black clamp to the negative terminal), attach the trans-
parent connecting pipe to the outlet pipe, and turn on the power
switch until new oil flows out (this step can bleed the air inside the ma-
chine).

OPERATING STEPS

●

Cycle cleaning

●
●
●
Add the transmission fluid into the machine's oil inlet.
Insert the transparent connecting pipe into an external new oil tan, turn
the left valve to the "Exchanging" position, and the right valve to the "Ex-
tracting" position; this will draw the oil from the external new oil tank.
Ensure the car is in a braking state and safely lift the vehicle.
Locate the connecting oil pipe between the transmission and the radiator
and disconnect one that is easy to remove.
Choose the corresponding adapter from the adapter box and connect it to
the machine's oil pipe (some models may require a special connector).
Connect the car's oil-outlet end to the machine's left-side "return oil" con-
nector, and the car's oil-inlet end to the machine's right-side "outflow oil"
connector (you can briefly start the engine to determine the direction of
oil-outlet and oil-inlet).
8