Omnitronic DSM-500 Bedienungsanleitung Seite 2

DRUM MICROPHONE SET
Drum Microphone Set
The DSM-500 microphone set was designed for professional studio recording and live applications
and is suitable for sound pick-up of percussion instruments. The exceptional frequency response
of the KDM-500 is specially designed for kick drums and other low-frequency musical instruments.
The small BDM-500 is ideal for tom-toms and snare drums, and the electret microphones IM-500
go well with the sound of cymbals and acoustic instruments like pianos and guitars. The electret
microphones operate on 48 V phantom power.
Safety Instructions
!
Maintenance and service operations are only to be carried out by authorized dealers.
Damage, caused by manual modifications on this device is not subject to warranty. If the
microphone is used for other purposes than originally intended or if it is not correctly connected,
the product may suffer damages and the guarantee becomes void.
!
Protect the microphone against humidity and heat. The ambient temperature must always be
between -5° C and +45° C.
Setting into Operation
1
Screw each microphone holder onto a stand with 3/4" or 5/8" thread. Insert the microphones
(IM-500) from above.
2
Connect the dynamic microphones KDM-500 and BDM-500 via balanced microphone cables
with 3-pin XLR plugs to the XLR microphone inputs of your audio unit (e.g. mixing console).
3
Connect the electret microphones IM-500 via balanced microphone cables with 3-pin XLR
plugs to the XLR microphone inputs equipped with +48 V phantom power of your audio unit
(e.g. mixing console). If the audio unit does not provide any phantom power, connect the
microphones to the audio unit via a phantom power supply unit (e.g. OMNITRONIC LH-051).
4
For voice recordings with the IM-500, use the supplied windshields to protect the capsules
from moisture.
Cleaning
For cleaning the microphones only use a soft lint-free and moistened cloth. Place the supplied
small bags containing moisture-absorbing crystals on top of the microphone heads afterwards.
Make sure not to allow any water to enter the devices and never use any solvent cleansers.
www.omnitronic.com