jet promac 378VBC Bedienungsanleitung Seite 3

1-1. Unpacking:
Before unpacking, make sure the carton configuration
not damaged, broken or parts extruded, if any above
defect case is found, contact your retailer to change a
new one as soon as possible.
Unpacking procedure:
1. Carefully open the carton. (Pull it from the bottom to
the top)
2. Take out and read the manual, check parts list and
relative attachments.
3. Inspect the machine outline if it is in normal condition
or not. Crack, rust, collapse and separate are strictly
prohibited.
4. Cleaning the surface of the machine.
5. Assemble the drill machine based on manual,
instruction guide.
The Model Machine is a heavy
machine. Serious personal
injury may occur if safe moving
methods are not used. To be
safe, get assistance and use
power equipment to move the
shipping crate and remove the
machine from the crate.
1-2. Transportation instruction:
1. Please refer to instruction manual in specification and
machine weight to arrange handling manner. Be sure
to use capable fork – lifter or hoist to lift of machine.
2. The handling and transportation shall be carried out
by qualified persons.
3. Fork – lift or hoist can be used in handling and shall
be operated by qualified driver.
4. While transportation, keep attention to the balance of
machine.
5. During handling, the machine shall be lifted only in
vertical direction.
6. Before handling, make sure all movable parts are
secured in their position and all movable accessories
should be removed from machine.
7. The steel rope should average pull the machine head,
table and column tightly.
8. Keep all the processes in a carefully and slightly
condition.
9. Bump or crash are strictly prohibited. It will cause
precision shift and electronic controller damaged.
WARNING
Typical lifting strap position.
1-3. Setting the machine instruction:
1. The machine base with setting hole will be set on
concrete floor.
The outlined procedures
of setting the machine
2. The dimension of setting hole:
Wrench Size 19m
1-4. Major Parts:
3
Lifting Straps
SETTED
MODEL AREA
SCREW
378VBC X=900×700 M12