A&D Medical UC-352BLE Bedienungsanleitung Seite 13

Ensuring a good connection
Be sure to use in a location where visibility between the two devices that you
want to connect is good. The connection distance is reduced by the structure of
buildings or other obstructions. In particular, connection may be impossible
when devices are used on either side of reinforced concrete.
Do not use Bluetooth® connection in the range of a wireless LAN or other
wireless devices, near devices that emit radio waves such as microwaves, in
locations where there are many obstructions, or in other locations where signal
strength is weak. Doing so may result in frequent loss of connection, very slow
communication speeds and errors.
Using close to an IEEE802.11g/b/n wireless LAN device may cause mutual
interference to occur, which may result in reduced communication speeds or
which may prevent connection.
In this case, switch off the power supply to the device that is not being used, or
use the scale in a different location.
If the scale does not connect normally when used near a wireless station or
broadcast station, use the scale in a different location.
The communication distance between this scale and the receiver device is about 10
meters. This distance is reduced by the conditions in the surrounding environment, so
be sure to check that the distance is short enough for a connection to be made after
measurement is complete.
Time settings
This scale has a built-in clock. The date and time of measurement are included in
the measurement data. The clock is synced with the clock in the mobile device.
There is no need to set the clock in the scale.
English 11