Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Pallet configuration
The M1, M2, M3 and M4 paddles on the back of the controller are programmable so that they can have the same functions as
the action buttons.
The M1 M2 M3 M4 palettes can remap a maximum of 14 buttons
●
By default, the M1 palette has the function of button 1
●
The M2 palette has by default the function of button 3
●
The M3 palette has by default the function of button 4
●
The M4 palette has by default the function of button2
There are 2 modes of paddle configuration:
A Remapping mode: 1 or more buttons can be set on 1 paddle
B Macro mode: sequences of functions of several buttons can be configured on 1 palette.
A Mode : Remapping
Example of operation on the M1 paddle
1) First press and hold the M1 paddle while holding it down, then press Share, the turbo LED stays on, the programming mode
is in progress.
2) Hold down the buttons you want to map, for example L1 and R2
3) Press M1 again to confirm the setting, the turbo LED goes out, the setting is successfully completed. Now if you press the
M1 paddle, it will have the L1 and R2 functions you have chosen.
4) Each pallet can replace one or more of the following buttons:
joystick, directional cross (up/down/right/left buttons)
In some games, the buttons are already programmed to perform several functions.
5) Memorizing the settings: once you have set up a paddle, it keeps the function(s) set up.
6) The instructions for setting up the other paddle are identical to the above steps.
B mode: Macro
Example of operation on the M1 paddle
1) First press and hold down the M1 paddle without releasing it, then press Option, the turbo LED remains on, the
programming mode is in progress.
2) Press any button you want to set in Macro mode, for example L1 and R2
3) Press M1 again to confirm the setting; the turbo LED goes out, the setting is successfully completed. Now if you press the
M1 paddle, the actions of the L1 and R3 buttons will follow each other in the order in which you pressed the relevant buttons
(if you first pressed the L1 button and then the R2 button, the actions of each of these buttons will follow in this order: L1
action and R2 action).
4) Each paddle can replace one or more of the following buttons:
joystick, directional cross (up/down/right/left buttons)
In some games, the buttons are already programmed to perform several actions.
5) Memorizing the settings: once you have set up a paddle, it keeps the action sequence(s) set up.
6) The instructions for setting up the other paddle are identical to the above steps.
PAIRING
The controller and its dongle are paired at the factory. If, due to a bug, replacement or in case of interferences, you need to
pair them anew, please proceed as follows :
1.
connect the USB dongle to a PC or PS4
2.
insert an unfolded paper clip inside the SYNC hole - ACT starts blinking;
3.
switch on the controller with the HOME button, keep pressing it until the controller's LED
bar starts blinking ;
4.
after a few seconds, ACT stays solidly lit and the LED bar shuts down - your controller is
paired.
SPECIFICATIONS
DC 3V --- 600mAh
Battery : Polymer Lithium-ion Battery
CUSTOMER SUPPORT
For answers to common questions, troubleshooting steps, and our Customer Support team, e-mail us at: contact@lexip.co.
,
,
,
, L1, L2, R1, R2, joystick must, left
,
,
,
, L1, L2, R1, R2, joystick must, left
10
Werbung
