Werbung
2. IMPORTANT SAFETY PRECAUTIONS
NOTICE: Failure to observe this precaution could result in personal injury
or product damage. Please read the instruction manual carefully before
using the product.
1. Use the product on a hard, level surface. Use on an unstable surface may result in electric shock or fire.
2. Ensure the power cord is connected to a power source matching the specified voltage to prevent damage and
potential safety hazards.
3. If the product overheats, unplug the power cord and allow it to cool for at least 20 minutes before resuming
use.
4. If abnormal noise or smoke occurs during operation, immediately unplug the power cord and contact customer
support.
5. Do not immerse the product in water. Clean the exterior with a dry cloth. Wash the blender container with
lukewarm water and a mild detergent; dry thoroughly. If water enters the product, immediately unplug the
power cord and contact customer support.
6. The Outer Container Lid and optional tumbler lid may cause malfunction when water enters the vacuum valve.
Do not immerse in water or other liquid and clean immediately.
7. Do not exceed the maximum fill line on the blender container. Please refer to the recommended blending
capacity (page 10). If the contents touch the inner container lid, it may interfere with the rotation of the blade
and prevent proper blending.
8. When blending foods with high tenacity or high viscosity (e.g., boiled soybeans, boiled potatoes) or dry foods
without liquid, the machine may malfunction. Refer to "Recommended Blending Capacity" (Note: There may be
differences in recommended volume depending on volume or weight of contents.)
9. Do not put anything other than food into the container to prevent damage or scratch the container or blade.
10. Do not add contents hotter than 104°F/40°C into the product container. It may cause damage to the product
and injury.
11. Water or debris in the vacuum port during vacuum may cause malfunction. Handle with care.
12. If the blender sounds an error tone and the LED blinks diagonally, stop using the product immediately and refer
to the operating instructions before resuming use.
13. Do not place the blender body, containers, or components in hot water (over 140°F/ 60°C) or a microwave. It
may cause damage to the product or injury.
14. In case of emergency, immediately shut down the machine by flipping the Main Power Switch to the off position
and then unplug the power cord.
15. Keep hands and utensils out of container while blending to reduce the risk of severe injury to persons or
damage to the Backspin Blender. A scraper may be used but must be used only when the blender is not
running.
16. Blades are sharp. Handle carefully.
17. Always operate blender with the lids in place.
18. Do not blend hot liquids to avoid thermal burn injury due to excessive pressure in the container.
19. Blade assembly is sharp, not locked in place, and removable. Handle with care. When handling blade assembly,
always hold by the shaft.
20. To avoid a risk of injury, before pouring with the lid removed, carefully remove the blade assembly.
21. The use of attachments, including canning jars, is not recommended and may cause a risk of injury to persons.
SAVE THESE INSTRUCTIONS
6
MAIN POWER SWITCH
Symbol for OFF Position
Symbol for ON Position
Werbung
