Werbung
7. ASSEMBLY & OPERATION
5
Slowly lower the CONTROL PANEL, then press
down until it clicks into place. Connect the power
cord, and then turn on the MAIN POWER SWITCH.
The LED will light up with a start sound, indicating
that the blender is in standby mode.
7
Once the cycle has finished, press the OPEN
BUTTON to lift up the CONTROL PANEL. Turn
the HANDLE counterclockwise to the unlocked
position
to remove the CONTAINER.
12
6
Select a preset button: AUTO, AUTO LOW, AUTO
HIGH, VACUUM, OR PULSE. See page 9 for more
details. To stop blending at any time, press the
button again.
CAUTION
• To prevent overheating, avoid using
the machine for over 5 minutes
at a time or continuously for 2
cycles. If the Overheat Prevention
System activates, the machine will
automatically shut off for about 10
minutes.
• Do not operate without any
ingredients.
• If you exceed the maximum capacity,
the LED will blink, and you will hear
an error beep.
• Carefully remove the BLADE before
transferring contents out of the
CONTAINER.
Werbung
