Shark Ninja PowerDetect IP1000 Serie Kurzanleitung Seite 5

Shark Cordless PowerDetect IP1000 Series
IMPORTANT SAFETY INSTRUCTIONS
WARNING: TO REDUCE THE RISK OF INJURY, USER MUST READ INSTRUCTION MANUAL • HOUSEHOLD USE ONLY
WARNING
When using an electrical appliance, to reduce the risk of fire, electric shock, injury, or
property damage, basic precautions should always be followed, including the following:
1 This vacuum consists of a motorised nozzle, wand, and handheld
vacuum. These components contain electrical connections, electrical
wiring, and moving parts that potentially present risk to the user.
2
Before each use, carefully inspect all parts for any damage. If a part is
damaged, discontinue use.
3
Use only identical replacement parts.
4 This vacuum contains no serviceable parts.
5 Use only as described in this manual.
DO NOT use the vacuum for any purpose other than those described in
this manual.
6 With the exception of the filters and dust cup, DO NOT expose any parts
of the vacuum to water or other liquids.
7 DO NOT allow the appliance to be used by children. Keep the appliance
and its cord out of reach of children. Do not allow to be used as a toy.
Close supervision is necessary when used near children.
GENERAL USE
8
This appliance can be used by persons with reduced physical, sensory
or mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning use of the appliance
in a safe way and understand the hazards involved. Cleaning and user
maintenance should not be done by children.
9 Always turn off the vacuum before connecting or disconnecting any
current carrying hoses, motorised nozzles, chargers, batteries, or other
electrical or mechanical parts.
10 DO NOT handle plug or vacuum with
wet hands.
11 DO NOT use without dust cup, filters, and brush-roll in place.
12 Only use Shark branded filters and accessories. Damage caused by non-
Shark filters and accessories may not be covered by the guarantee.
13 DO NOT put any objects into nozzle or accessory openings. DO NOT use
with any opening blocked; keep free of dust, lint, hair, and anything that
may reduce airflow.
14 DO NOT use if nozzle or accessory airflow is restricted. If the air paths
or the motorised floor nozzle become blocked, turn the vacuum off.
Remove all obstructions before you turn on the unit again.
15 Keep nozzle and all vacuum openings away from hair, face, fingers,
uncovered feet, or loose clothing.
16 DO NOT use if vacuum is not working as it should, or has been dropped,
damaged, left outdoors, or dropped into water.
17 Use extra care when cleaning on stairs.
18 DO NOT leave the vacuum unattended while powered on.
19 When powered on, keep the vacuum moving over the carpet surface at
all times to avoid damaging the carpet fibres.
20 If you have delicate or wool carpets, particularly loop pile, please try the
vacuum on a hidden area first to ensure the spinning brush-rolls do not
damage or unpick carpet fibres.
21 DO NOT use to pick up:
a) Liquids
b) Large objects
c) Hard or sharp objects (glass, nails, screws, or coins)
d) Large quantities of dust (including drywall, fireplace ash, or embers).
DO NOT use as an attachment to power tools for dust collection.
e) Smoking or burning objects (hot coals, cigarette butts, or matches)
f) Flammable or combustible materials (lighter fluid, petrol, or
kerosene)
g) T oxic materials (chlorine bleach, ammonia, or drain cleaner)
READ AND SAVE THESE INSTRUCTIONS
VISIT qr.sharkclean.com/IP1000EUSERIES OR
SCAN HERE
FOR FULL INSTRUCTIONS & REPLACEMENT PARTS
© 2024 SharkNinja Operating LLC.
IP1000EUSeriesV1_QSG_MP_240729_Mv1
22 DO NOT use in the following areas:
a) Poorly lit areas
b) Wet or damp surfaces
c)
Outdoor areas
d) Spaces that are enclosed and may contain explosive or toxic fumes
or vapours (lighter fluid, petrol, kerosene, paint, paint thinners,
mothproofing substances, or flammable dust)
23 Turn off the vacuum before plugging in or unplugging the charger.
24 Turn off the vacuum before any adjustment, cleaning, maintenance or
troubleshooting.
25 During cleaning or routine maintenance, DO NOT cut anything other
than hair, fibres, or string wrapped around the brush-roll.
26 Allow all filters to air-dry completely before replacing in the vacuum to
prevent liquid from being drawn into electric parts.
27 DO NOT modify or attempt to repair the vacuum or the battery yourself,
except as indicated in this manual.
DO NOT use the battery or vacuum if it has been modified or damaged.
Damaged or modified batteries may exhibit unpredictable behavior
resulting in fire, explosion or risk of injury.
28 Turn off all controls before unplugging.
29 Always turn off this appliance before connecting or disconnecting
motorised nozzle or hand tool.
30 If the supply cord is damaged, it must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
BATTERY PACK
31 The battery is the power source for the vacuum. Carefully read and
follow all charging instructions.
32 To prevent unintentional starting, ensure the vacuum is powered off
before picking up or carrying the vacuum. DO NOT carry the appliance
with your finger on the power switch.
33 For IP1000 Series, use only the DK30A-263100H-V or YLJX2I-E263100
chargers.
34 Keep the battery away from all metal objects such as paper clips, coins,
keys, nails, or screws. Shorting the battery terminals increases the risk of
fire or burns.
35 Under abusive conditions, liquid may be ejected from the battery. Avoid
contact with this liquid, as it may cause irritation or burns. If contact
occurs, flush with water. If liquid contacts eyes, seek medical help.
36 Battery should not be stored at temperatures below 3°C (37.4°F) or
above 40°C (104°F) to maintain long-term battery life.
37 DO NOT charge battery at temperatures below 5°C (40°F) or above
40°C (104°F). Charging improperly or at temperatures outside of the
specified range may damage the battery and increase the risk of fire.
38 Store the appliance indoors. DO NOT use or store it below 3°C (37.4°F).
Ensure the appliance is at room temperature before operating.
39 DO NOT expose the battery to fire or temperatures above 130°C (265°F)
as it may cause explosion.
40 Use appliances only with specifically designated battery packs. Use of
any other battery packs may create a risk of injury and fire.
41 Disconnect the battery pack from the appliance before making any
adjustments, changing accessories, or storing appliance. Such preventive
safety measures reduce the risk of starting the appliance accidentally.
42 For IP1000 series use only Shark battery pack XBATR640EU (21.6V
3750mAh 81wh ).
Please be sure to read and save the warnings on other side prior to using your unit.
QUICK START GUIDE
How to set up the IP1000 Series
Shark Cordless PowerDetect Vacuum.
ASSEMBLY CHARGING
1. Slide the Wand onto the neck of
the Floor Nozzle until it clicks
into place.
2. Align the Hand Vacuum nozzle
opening with the top of the wand
and slide it on until it clicks into
place.
For proper operation, ensure
all components are completely
connected and clicked
into place.
To charge the battery, remove it
Handheld
from the vacuum and insert into the
Vacuum
charging sleeve. Once the battery
is showing as fully charged reinsert
into the handle compartment on the
vacuum.
EMPTYING THE DUST CUP
2.
(Click)
Flex
Wand
To empty the bin, hold it over the
rubbish bin and press the release
button on the side. The bottom will
open to release the debris.
1.
(Click)
NOTE: The main unit comes with a partial
charge. For maximum runtime, charge
fully before first use (approximately
6 hours).
Floor Nozzle
FLEXOLOGY FLEX STORAGE
To engage the Flexology feature, To put the vacuum into storage
press the unlock button on the back mode, press the Flexology wand
of your Flex Wand. unlock button while folding the
handheld vacuum forward until it is
For straight wand cleaning, return
resting against the wand.
the wand to its original angle. You
will hear a click when it is securely
back in place.
POWER ON/OFF MODE SELECTION
Press the button on the UI To toggle between ECO, DETECT,
Screen to turn on power. To turn and BOOST modes, press the mode
off power, press the button again. selection trigger on the handle.
MODES EXPLAINED
ECO MODE Maximises runtime
SENSES YOUR ENVIRONMENT TO OPTIMISE
DETECT MODE
YOUR CLEANING EXPERIENCE.
Detect technology is ONLY activated in Detect mode and is activated
automatically when the unit is in use.
Dirt Detect: Identifies
dirtier high-traffic
areas and automatically
boosts suction power to
pull in hidden dirt.
NOTE: Hand Vacuum
UI and Nozzle Lights
Clean Floor Medium Dirt Heavy Dirt
are Synched.
Low Suction Medium Suction High Suction
ADDITIONAL DETECT TECHNOLOGY
Dirt Detect: Identifies dirtier high-traffic areas and automatically boosts
suction power to pull in hidden dirt.
Floor Detect: The brushroll responds to surface changes and
automatically adjusts to optimise your clean.
Light Detect: Senses low-light situations and automatically illuminates
dark areas to help you spot debris.
BOOST MODE
Maximises suction
IMPORTANT: FILTER CLEANING
1. To access filter, press the dust 2. Pull the release tab to remove the
cup release button and remove filter for the vacuum.
the dust cup.
3. After cleaning, slide the filter
back into the vacuum.
NOTE: For best results, clean your filters at least once a month and replace the filters
regularly. To clean filters, clear loose debris and rinse with cold water ONLY to prevent
damage from cleaning chemicals. Allow all filters to dry fully before reinstalling to
prevent liquid from being drawn into electrical parts. Maintaining your Filters will
ensure successful cleaning.