Homend ROYALTEA PLUS 2 IN 1 Benutzerhandbuch Seite 33

Please note:
Thanks to the keeping warm feature, it will
be active for 30 minutes after your water
reaches 100°C. After 30 minutes, your
machine will turn itself off. After the water
of the kettle has boiled, the
machine will switch off automatically. The
keeping warm mode will be
deactivated automatically.
Please note:
If you want to change or cancel your
selection after selecting a mode,
press the mode selection button ''
until ''OFF'' appears on the display.
When the water temperature reaches 100 °C,
your tea maker will notify you by saying "your hot
water is ready''. Your tea maker will keep your
water hot for 3 hours and will turn itself off after
3 hours.
Please note:
Do not press the automatic tea brewing button
when there is no water in the water container.
Note: Do not press the Turkish Coffee
preparation button when the kettle is in the
container
U S E R ' S M A N U A L K U L L A N I M K I L A V U Z U
Automatic tea brewing:
Open the teapot cover and remove the steel
tea filter, pour enough tea into the filter and
place it in the teapot. Fill the water
container at the back with water. The water
level must not exceed the MAX level. When
the second button '
the tea brewing button will start to flash
and will continue to flash until your water is
boiled.
When the water temperature reaches 100°C,
your tea maker informs you that "your hot
water is ready, your tea is brewing" and the
''
tea brewing button stops flashing. Then, your
automatic tea brewer will brew your tea for
you by delivering water from the water
container to the teapot little by little.
After the water delivery is finished, your water
will be boiled automatically at certain intervals
so that the water in your lower teapot does
not cool down. After 3 hours, it will be turned
off automatically.
Please note:
Do not press the automatic tea brewing button
when there is no water in the water container.
WARNING: Do not move the upper water
delivery container during tea brewing.
NOTE: : If you want to change or cancel your
selection after selecting a mode, you should
press the mode selection button once. Then
"OFF" will appear on the display.
' is pressed once,
0 3 3 1