Werbung
Safety Instructions
*Please read this instruction manual thoroughly before using your new Lokithor
multi-function vehicle emergency Jump Starter
1. Please follow all instructions in this manual for safe Lokithor operation. Failure to follow all
instructions in this manual or improper use of Lokithor products may result in property damage
and or personal injury.
2. Lokithor is designed for starting 12V engines. It is not designed for starting vehicles or engines
exceeding product specifications in voltage or displacement.
3. Warning: when using FORCED START mode ALL Lokithor safety features ARE DISABLED. Use
extreme caution: Do not allow the clamps to short together or touch when using FORCED START
mode. Read and understand all safety procedures before using Forced Start mode.
4. For best longevity of your Lokithor product we recommend a quarterly maintenance program.
Please fully charge your new Lokithor product when you receive it. After initial charge, inspect the
charge level of the device every 3 months and charge if needed. Also you may use the power bank
feature during this time to discharge the battery to approx 50% and then recharge Lokithor to full
before placing it back in your vehicle. This good practice will help ensure you get the best product
lifespan and that Lokithor is always ready for the next emergency.
5. Do not use a damaged Lokithor. If your device has had impact damage, has been hit, dropped
or exposed to any other physical damage do not use it. Using a damaged Lokithor may cause a
dangerous situation.
6. Do not attempt to use Lokithor while it is charging.
7. Do not disassemble the Lokithor. There are no user serviceable parts inside.
8. Use extra caution when working around or with car batteries and Jump starters. Avoid dropping
metal objects on battery terminals while using Lokithor. Any metal object can cause a dangerous
short circuit condition. This may result in equipment damage, explosion and or personal injury .
9. When using Lokithor for starting an engine, ensure that the positive and negative cable clamps
are in good working condition and have a strong connection with the positive and negative
terminals of the battery.
10. Do not allow sparks and or flames to contact the jump starter or engine.
11. To prevent short-circuit and or sparks from damaging the jump starter, make all connections to
the engine battery before attempting to power on Lokithor. DO NOT clamp the positive and
negative poles of the cable clamps to each other and DO NOT connect clamps to the same piece
of metal(short circuit).
12. Lokithor is not intended for use by children. Do not leave the jump starter in a place where
children can easily reach it.
13. Do not expose Lokithor to rain or snow.
14. Do not leave the Lokithor in extreme environments for long periods of time (extreme heat
above: >131℉ (55°C), or extreme cold below: <14℉ (-10°C), humidity: >80% humidity).
15. When not using Lokithor please store it in a cool and dry place.
16. Please ensure a good maintenance program for your Lokithor: Charge it in a timely fashion
after being used, or when it is in a discharged condition. Failure to do so may cause an
over-discharge condition leading to low internal battery voltage or an out of power condition.
Long periods of time with low or no power may cause permanent product failure.
Werbung
