Care Instructions - Reflecta Crystalline Rollo Bedienungs-/Montageanleitung

Do not start installation until you have read the complete operating
instructions
Instructions for use
Only use the screen as intended and protect it from heat and moisture.
-
Observe the installation instructions and carry out the installation with another
-
person to ensure safe installation.
The projection screen can be mounted on the ceiling or on the wall. The
-
choice of wall plugs and screws must be made according to the existing
surface (masonry, concrete, wood, metal, etc.). Tighten the screws firmly, but
not too tightly. Over-tightening (e.g. with a cordless screwdriver) can cause
damage and impair the secure hold of the screen.
To ensure trouble-free operation, the screen may only be used indoors; it is
-
not suitable for outdoor use.
We recommend waiting approx. 2 hours after delivery before installing the
-
screen. This allows the screen to acclimatize. When changing from a very cold
to a warm environment (or vice versa), a waiting time of approx. 24 hours must
be observed.
The manufacturer accepts no liability for damage to property or personal injury
-
if the screen is used outside the recommended specifications or if it is installed
incorrectly.

Care instructions

Stains on the fabric surface should be avoided. These may not be able to be
-
removed. Please do not use the screen in dusty environments.
-
Never use alcohol or other cleaning agents containing solvents to clean the
screen. If necessary, use a mild soapy solution (max. 5%) to remove any dirt
from the surface. Only use a soft and clean cloth. Then wipe again with clean
water to remove all soap residue. The cloth should not be wet, only slightly
damp, and must be completely dry before retracting.
Avoid contact with pointed or sharp objects at all costs. These can
-
permanently damage the projection screen surface.
- Inspect the surface to ensure that it is free of insects, dirt or other foreign
objects before rolling it back into the housing.
7