Operating Instructions; Connecting The Scanner; Read Dtc - Strex Obd2 Bedienungsanleitung

OPERATING INSTRUCTIONS

Connecting the Scanner

1. Turn off the ignition switch.
2. Locate the vehicle's 16-pin data link connector.
3. Plug the OBD II cable into the vehicle's DLC.
4. Turn on the ignition and engine.
5. When finished, the device automatically enters the diagnostic interface.
CAUTION! ALWAYS MAKE SURE THE MOTOR IS OFF BEFORE CONNECTING
THE SCANNER TO AVOID ERROR MESSAGES.

Read DTC

Select [OBD] and then [Read DTC], and press the [OK] button to continue, if there is a fault code, the
screen will display the code (Fig. 2), if you find more than one DTC fault code, please use the left/
right buttons to turn the page to check all the codes.
Figure 1
DLC interface
Figure 2
39