Tunturi CARDIO FIT T10 Montageanleitung Seite 12

English
⚠
WARNING
• Improper connection of the equipment-
grounding conductor can result in a risk
of electric shock. Check with a qualified
electrician or serviceman if you are in doubt
as to whether the product is properly
grounded. Do not modify the plug provided
with the product if it will not fit the outlet;
have a proper outlet installed by a qualified
electrician.
Assembly instructions
Description illustration A
The illustration shows what the trainer will looks
like after the assembly is completed.
You can use this as a reference during your
assembly, but do follow the assembly steps
always in the correct sequence as showed in the
illustrations.
Description illustration B
The illustration shows what components and parts
you should find when un-boxing your product.
‼
NOTE
• Small parts can be hidden/ packed in hollow
spaces in the Styrofoam product protection
• If a part is missing, contact your dealer.
Description illustration C
The illustration shows the hardware kit that comes
with your product.
Assembly (fig� D)
The product comes fully assembled in the carton.
The product comes in the folded state in the
carton.
‼
NOTE
• To unfold the treadmill see "Folding &
Unfolding the equipment" section in this
manual.
12
⚠
WARNING
• Carry and move the equipment with at least
two persons.
⚠
CAUTION
• Place the equipment on a firm, level surface.
• Place the equipment on a protective base to
prevent damage to the floor surface.
• Allow at least 100 cm of clearance around the
equipment.
Additional environmental information
Packaging disposal
Government guidelines ask that we reduce the
amount of waste material disposed of in land fill
sites. We therefore ask that you dispose of all
packaging waste responsibly at public recycling
centres.
End of life disposal
We at Tunturi hope you enjoy many years of
enjoyable use from your fitness trainer. However,
a Time will come when your fitness trainer will
come to the end of its useful life. Under 'European
WEEE Legislation you are responsible for the
appropriate disposal of your fitness trainer to a
recognised public collection facility.
Use
Master power switch (fig� E-2A)
The equipment is equipped with a master power
switch to shut down the equipment completely.
To start the equipment:
- Insert the mains plug into the equipment.
- Insert the mains plug into the wall socket.
- Set the master power switch to the on position.
To stop the equipment:
- Set the mains power switch to the off position.
- Remove the mains plug from the wall socket.
- Remove the mains plug from the equipment.
Safety key (Fig F-4)
The equipment is equipped with a safety key that
must be properly placed onto the slot on top of
the handrail to start the equipment. If you remove
the safety key from the slot, the equipment will
stop immediately.
- Place the safety key onto the slot on top of the