Calypso Watches IKMK5804M Betriebsanleitung Seite 5

I
ENGLISH INSTRUCTION MANUAL
a. The alarm on indicator
snooze alarm on indicator (SNZ) are shown on the display in all modes while these
functions are turned on.
b. The snooze alarm on indicator flashes during the 5-mintue intervals between alarm.
c. Displaying the alarm mode setting screen automatically changes the alarm type to one-
time alarm.
d. Changing the timekeeping mode setting screen during a 5-minute interval between snooze
alarm stops the current snooze alarm operation (but snooze alarm remains as the alarm
type setting).
e. If a snooze alarm time is reached while you are setting the current time in Real Time Mode,
the alarm sounds only once. Subsequent snooze alarm operations are not performed.
f. After a snooze alarm time is reached, you can perform the following steps during any
5-minute interval between alarm to stop the snooze alarm operation.
• Alarm Operation: The alarm tone sounds at the preset time for about 15seconds. Press
any button stops the alarm tone operation.
• To turn the Hourly Time Signal on or off: In Alarm Mode, press D key to display the
Hourly Time Signal screen, press C key to turn it on and off. The Hourly Time Signal
while this function is turned on.
CHRONOGRAPH
• The display range of the chronograph is 23hours, 59minutes,59.99seconds.
• The chronograph continues to run, restarting from zero after it reaches its limit, until you
stop it.
• The chronograph measurement operation continues even if you exit the Chronograph
Mode.
• Exiting Chronograph Mode while a split time is frozen on the display clears the split time
and returns to elapsed time measurement.
To measure times with the chronograph:
ELAPSED TIME:
D KEY D KEY
Start Stop
Stop
SPLIT TIME:
D KEY C KEY
Start Split
(SLP Display)
TWO FINISHES:
D KEY C KEY
Start Split
First Runner Second Runner
Finishes.
Display Time Of
First Runner
By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making products must
be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other authorized collection
point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and protecting our health.
and the
on indicator is shown on the display in all modes
D KEY D KEY
Restart Stop
C KEY D KEY
Split Release Stop
D KEY C KEY
Stop Split Release
Display Time Of
Finishes Second Runner
DUAL TIME
• In Dual Time Mode, hold down C key until the hour setting start to flash, which indicates the
setting screen.
• Press B key to change the selection in the following sequence:
HOUR
• Press D key to increase the setting.
• Press C key to exit the setting screen.
COUNTDOWN TIMER
The countdown timer can be set within a range of 1 minute to 24 hours. An alarm sounds
when the countdown reaches zero.
To set the countdown start time:
a. In Countdown Mode, hold down D key until the hour setting of the countdown start time
starts to flash, which indicates the setting screen.
b. Press B key to move the flashing between the hour an minute settings.
c. Which a setting is flashing, use D key to change it.
d. Press C key to exit the setting screen.
• When the end of the countdown is reached, the alarm sounds 15s or until you stop it by
pressing any button. The countdown time is automatically reset to its starting value after
the alarm stops.
• Press D key while a countdown operation is in progress to pause it. Press D key again
to resume the countdown.
• To completely stop a countdown operation, first pause it(by pressing D key), and then
press C key. This returns the countdown time to its starting value.
• The countdown timer measurement operation continues even if you exit the Countdown
Timer Mode.
D KEY
Clear
C KEY
Clear
C KEY
Clear
IKMK5804M
MINUTE