Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The original speaker is plugged in at three points on the panel. If necessary, use a plastic
wedge to lever out the speaker. To unlock the connectors, use either a small screwdriver or
a paper clip. Connect the supplied crossover to the original connection
black) and the other end to one of the two connection terminals of the EM-MBCI
Connection
variant
1:
If the original center speaker has two connections,
emergency
call function without the included crossover, otherwise an error message will
appear in the radio display. This error message disappears
loudspeaker has been correctly connected (i.e. without the crossover) to the SOS cable.
Connection
variant
2:
If the original center has only one connection (SOS function only), you must connect the cable
for the SOS emergency
sage will appear in the radio display. This error message
the loudspeaker has been correctly connected (i.e. without the crossover) to the SOS cable.
Connect
the included
end of the crossover to the original connector.
If you use a separate amplifier for the EM-MBC2, connect the amplifier output to the crosso-
ver as follows: If you want to keep the filter function, cut the cable in front of the shrink tube.
If you use the filter of the amplifier, cut the wire after the shrink tube (set cut-off frequency
to 200 Hz/12 dB Oct.).
Stow the cables and crossovers and place the speaker on top of the three mounting holes.
Now push the speaker
are firmly locked.
Mount the cover. To do this, place the clips of the cover on the corresponding
gently push the cover down until the clips snap into place.
call function without the included
crossover
to the second
at the ends with the mounting
you must connect the cable for the SOS
automatically
crossover,
disappears
terminal
of the EM-MBC2.
balls in the mounting
5
cable (gray / gray
as soon as the
otherwise
an error mes-
automatically
as soon as
Connect
the other
holes until they
holes and
Werbung
