eta Aquamist Bedienungsanleitung Seite 21

• Never have the appliance connected to the wall socket unattended!
• NOTE: Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and
vulnerable people are present.
• The appliance must not be immersed in water or other liquids (not even partially)! If the
appliance falls in water, do not take it from the water! First disconnect the power cord
plug from the electrical socket, and then take out the appliance from the water. In such
cases, bring the appliance to a specialised service centre to verify its safety and proper
operability.
• ATTENTION: Do not use this heater in series with an external timer, remote controller or
any other device that switches on the appliance automatically, since a fire risk exists when
the heater is accidentally covered or displaced at the moment it switches on.
• The product is intended for home use. It is not intended for commercial use!
• This appliance is not intended for outdoor use.
• Do not handle the appliance with wet hands.
• Do not plug the power cord in the electrical socket and do not unplug it with wet hands
or by pulling the power cord!
• The appliance must not be used in a damp or wet environment and in any environment
with the danger of fire or explosion (premises where chemicals, fuels, oils, gases, paints
and other flammable or volatile materials are stored).
• After use, disconnect the appliance from the mains, let it cool down and pour out the
remaining water.
• Do not let the appliance unattended until it cools down!
• According to the instructions in the "Maintenance" section, regularly remove incrustation
from the steam cleaner.
• Never switch the appliance on when the tank is empty! Do not exceed the maximum
permissible water volume of 250 ml! If the water tank is overfilled, spontaneous discharge
of hot water through the safety valve is imminent, as well as hot water spraying instead
of steam discharge from the steam cleaner nozzle. Once steam production stops, the
internal tank is empty, and must be replenished following the steps described below.
• Only fill the water tank after unplugging the power cord from wall socket, and after the
appliance has cooled down.
• Only fill the water tank with clear water (if water in your home is too hard, you can mix it 1:1
with distilled water, or use demineralised water). Do not use any chemical agents and other
liquids, such as rust removers, aromatic substances, alcohol, various detergents, etc.
• Never use the appliance without properly mounted safety valve! The valve is
designated to safely produce steam under pressure. Thanks to the valve's safety
mechanism, it can only be unscrewed after the tank pressure drops down. Never apply
force when opening the valve! Protruding plug in the safety valve centre indicates the hot
steam pressure inside the water tank. Never press down the plug trying to unscrew the
safety valve, and never attempt to unscrew the safety valve when the plug is protruding!
There is a risk of scalding!
EN - 21
EN