DEFA JLR Gebrauchsanleitung Seite 5

SAFETY
Please read the manual carefully before use.
Inexperienced users, children aged 8 and above and persons with reduced physical or mental capabilities must only use this product under supervision or after
having read or been given instructions on safe use.
Do not attempt to charge non-rechargeable batteries.
Do not use the AGM charging program on a Li-Ion battery or the Li-ion charging program on a lead-acid battery. After use, disconnect the mains power before
disconnecting from the battery.
Only use the charger in well-ventilated area and on vented batteries.
This charger must be repaired by authorized DEFA repairers or specialists.
Never intentionally connect the charger incorrectly, even though it is protected against short-circuiting and reverse polarity. Do not install the charger in a highly
flammable environment.
Do not charge a damaged battery.
• During charging, batteries may release highly explosive gases. Take care not to have sparks, open flames, cigarettes or similar in the vicinity of the battery and
always ensure sufficient ventilation.
• Battery acid is corrosive and harmful. It damages clothes, metal and varnish. In case of spillage and contact with skin, wash and rinse thoroughly with water and
consult a doctor.
• Lead and other chemicals that are used in batteries are toxic. Wash skin and hands thoroughly after working with batteries.
ABOUT THE CHARGER
DEFA Showroom Charger is based on modern switch-mode technology. This charger represent the latest technology within battery charging and will give the
batteries optimal performance and durability. It is well suited to charge lead/acid, AGM, EFB, GEL and lithium-ion batteries up to approx. 600 Ah for a unlimited
time. The charger can be used with up to 45A parallel consumption at the same time as it charges the batteries.
USE
Read the user guide carefully.Please contact DEFA if you are unsure about how to safely use the charger.
Connect red clamp to (+) and black clamp to (-) or the connection point recommended by the vehicle manufacturer. The charger is intended for use with lead/
acid, AGM, EFB, GEL and Lithium batteries. The battery manufacturer's recommendations must always be taken into consideration.
Connect the DC charging cable to the charger. See C page 3.
Connect the AC mains cable to the charger. Push the power button once. See B, page 2. The charger will start and initialize the pre-analyze process. To turn OFF
the charger, push the power ON/OFF button again.
NOTE: To make sure the correct charging voltages are applied, the charging cables must not be shortened or made longer.
EN
5