General Safety Precautions; Safety Rules For The Operation Of The Dust Collector - Tyrolit Contec R2D2 Betriebsanleitung

GeneRal SafeTy PReCaUTIOnS

1.
1.1
General Safety Precautions

Safety rules for the operation of the dust collector

Information
The dust collector is constructed according to existing safety rules and regulations. These
technical precautions should not be removed or changed under any circumstances. While
operating the machine the following points should also be kept in mind:
Attention !
• Disconnect the machine before commencing any servicing or maintenance work - however meni-
al. Never unplug the machine while it is still running. This notice can be found in every manual but
in nearly every part of the dust collector high electrical currents are transmitted. The danger of in-
jury is therefore not only from electric shock, but also from moving parts of the machine.
• Never wear loose or badly fitting clothing. Flapping sleeves may be pulled into the machine cau-
sing serious injury.
• The use of protective equipment such as goggles with side protection and ear protectors is re-
quired. All persons present in the working area of the machine must wear the required protective
equipment.
• All rotating parts of the machine are suitably protected by covers, which prevent clothes or similar
from entering the machine. Under no circumstances should these covers be removed before the
machine is switched on.
• The dust collector should be switched off immediately if any unusual noises or vibrations are de-
tected whilst the machinery is in operation. A thorough check must be carried out in order to de-
tect the cause.
• The machine operator must never leave the machine unattended at any time during operation.
• Before leaving the dust collector the operator must switch off the machine and make sure that it
cannot accidentally roll from it›s position. Also disconnect the machine from the mains.
• Check the power cables regularly as damage may have occurred while operating the machine. Al-
ways disconnect the cables before examination and treat all electrical parts with extreme care.
• Always re-connect all the safety plates and covers after any maintenance work.
• If the noise of the dust collector exceeds 90 dB(A) ear protections have to be worn by the opera-
tor.
• Only tools or spareparts approved by CONTEC / TYROLIT may be used.Bei Schallpegeln über 90
dB(A) müssen Schallschutzmittel vom Bediener getragen werden.
Danger of burning!
The compressor on the power unit is heating up during operation. Don't touch any
part of the compressor.
5