Werbung
Verfügbare Sprachen
Verfügbare Sprachen
5. Funtion and operation
Temperature control
- Power Supply: connect to 12V/24V DC or 100~240V AC power(using dedicated adapter).
- Display Screen Initialization: connect to the power supply, the buzzer will make a long
beep, and the display will be on for 1 second then enter the normal operating mode.
- Power ON/OFF: press to switch ON/OFF.
- Left/Right Compartment Setting: under the running state, long press and
same time for 3 seconds to switch ON/OFF the left compartment, long press
the same time for 3 seconds to switch ON/OFF the right compartment, two compartments
cannot be switched off at the same time.
- Temperature Setting: press or
left/right compartment temperature setting. Press or to adjust the temperature.
The setting will be saved after stop operating for four seconds, the temperature displayed
is the current temperature of the compartments, it'll take a while to reach the set
temperature. Temperature setting range: -20~20°C (4~68°F).
- Cooling Mode: under the running state, press
(energy saving mode). (*Factory setting is HH.)
- Battery Protection Mode: under the running state, long press for 3 seconds until the
left screen flashes, then press again to switch High, Medium and Low .
(*Factory setting is High).
Voltage Reference:
Input
DC12V
Modus
Cut out
Low
8.5V
Medium
10.1V
High
11.1V
The voltage is a theoretical value, there may be deviation in different environments. Due to
the different output voltages between vehicles, H must be set when the product is connected
to car power and as M or L when connected to a portable battery or other backup battery.
Left compartment
, the left screen will flash, then press to switch
From left to right: Low/Medium/High.
DC12V
DC 24V
Cut in
Cut out
10.9V
21.3V
11.4V
22.3V
12.4V
24.3V
20.
Set
On/Off
Right compartment
to switch HH(fast cooling mode) or Eco
DC24V
Cut in
22.7V
23.7V
25.7V
at the
and
at
Werbung
