Installation Mode; Programming Instructions - I-Tec Shading Programmieranleitung

Start and stop heat protection mode
If the automatic heat protection mode is activated, pressing the
buttons interrupts this function until the following day.
Interruption of sunrise mode
If the sunrise mode is activated, the following sunrise can be skipped by
pressing buttons or in the evening; this means that the blinds will not
automatically raise the following morning.
Adjusting the top position
If the blinds fail to raise all the way to the top, the top position can be re-
adjusted. To do so, press the button
incrementally and their position is reset.
Setting individual fixed position
The or buttons allow you to move the blinds to the
1.
desired end position and adjust the slats as desired.
Press and hold the buttons simultaneously (approx.
2.
7 sec.)
3. The new fixed position has been saved when the status LED
flashes green briefly.

INSTALLATION MODE

The blinds are programmed exclusively in installation mode. You can switch
between operating and installation mode by pressing the programming button,
which is located on the back of the radio transmitter, several times. To do
this, the control unit must be removed from the window frame or, if you have a
handheld transmitter, its casing must be opened.

Programming instructions

Overview of function menu
press briefly – individual menu selection
Blue - activate desired automatic function
¢
Green - Programme blinds
¢
Red - Delete radio transmitter from blinds
¢
White - Adjust blind transparency
£
Manually trigger blind detection
If no selection is made or no other button is pressed for 5 seconds, the radio
transmitter returns to operating mode.
28
or
for 30 seconds until the blinds raise
¢ £ £ £
©
¢ £ £ £
Activate desired automatic function
¢
If an automatic function is activated, the I-tec Shading controller automatically
recognises sunrise, sunset or room overheating following a programming phase
of max. 36 hours – depending on which automatic function is activated.
1. Select function menu
2. press briefly = confirm selection
press briefly = select search modes
= finds Venetian blinds in the immediate
© © £ £
vicinity 5.1
= finds all registered Venetian blinds
£ © © £
3.
= finds Venetian blinds that have been
£ £ © ©
programmed in the selected channel
(It is possible to synchronise blinds with
each other)
4. press and hold = confirm selection/ search starts
5.1 For search mode
© © £ £
If a Venetian blind is found, the first LED flashes
6.1 . If no Venetian blind is found, no LED
© £ £ £
illuminates.
press briefly = allows you to switch through all the
Venetian blinds found and select the one you want
The radio transmitter aligns the blinds:
7.1 = Blind 1
© £ £ £ £ £ £ ©
= Blind 2
£ © £ £ © © £ £
= Blind 3
£ £ © £ © £ © £
Check active blind with or
8.1 press and hold = confirm selection
5.1
5.2
ª ª ª ª
and
£ © © £
= Blind 4
= Blind 5
= Blind 6 ...
!
EN
¢
29