Operating Mode - I-Tec Shading Programmieranleitung

Overview of I-tec Shading radio transmitter
Button Function
Selection button
Key up
Key down
Programming
button
LED LIGHT STATUS
Illuminated LEDs
first LED illuminates
¢ £ £ £
second LED illuminates
£ ¢ £ £
third LED illuminates
£ £ ¢ £
fourth LED illuminates
£ £ £ ¢
all LEDs illuminate
¢ ¢ ¢ ¢
Flashing LEDs
first LED flashes
© £ £ £
second LED flashes
£ © £ £
third LED flashes
£ £ © £
fourth LED flashes
£ £ £ ©
all LEDs flash
© © © ©
LED chase light
ª ª ª ª
(both ways)
LED chase light
¦ ¦ ¦ ¦
(from left to right)
LED chase light
§ § § §
(from right to left)
26
= Back
= Front
Installation
Operating
mode
mode

OPERATING MODE

The blinds are controlled in operating mode. All movements and rotations
are performed in this mode. Automatic functions can be started or paused in
operating mode. The individual fixed position can also be controlled and set by
the user.
Channel selection
press briefly Display active channel
Switch channel
press briefly again
press and hold direct selection of all channels
Movement of blinds
press briefly
press briefly
or press briefly again
Slat rotation
or keep the button Slats are rotated incrementally as long as the
pressed button remains pressed
Individual fixed position
press simultaneously Blinds move to the programmed individual
fixed position
A fixed position is preset at the factory: Blinds are down, with Venetian blind
set to 50% transparency.
Start automatic functions
1. press briefly simultaneously = confirm selection
2. Automatic functions activated
Pause automatic functions
1. press briefly simultaneously = confirm selection
2. Automatic functions deactivated
No automatic functions are preset at the factory. These must be activated in
installation mode.
or
Blinds move up
Blinds move down
Blinds stop
or
¦ ¦ ¦ ¦
§ § § §
EN
27