Trust MACC-200 Bedienungsanleitung Seite 10

EN
MACC-200 MATTER & START-LINE SMART SOCKET DIMMER
The minimum brightness starts at position 1. Every time the button on the dimmer is pressed shortly, the lamp
will dim 1 position deeper (1-2-3-4). If you press the button shortly again after position 4, the minimum dimming
position will return to position 1.
Hold the button on the dimmer down for 3 seconds again when the correct dimming range has been
D
selected.
The lamp will go ON-OFF-ON-OFF to confirm the selected dimming position.
E
OPTIONAL: RESET MATTER
Warning: After performing this step, you will no longer be able to control the dimmer via Matter, and you will
need to remove the dimmer from the Matter App. (The paired Start-Line transmitters will not be removed).
To reset Matter, press and hold the button on the dimmer for 15 seconds until the LED blinks red.
A
When the LED blinks red, press and hold the button again for 6 seconds.
B
The connected lamp will turn ON-OFF-ON-OFF to confirm the reset.
C
OPTIONAL: REMOVE A SINGLE START-LINE TRANSMITTER
Shortly press the button on the dimmer to activate the pairing mode. The pairing mode will be active for 12
A
seconds, and the LED indicator on the dimmer will blink green.
While the pairing mode is active (within 12 seconds), send an OFF signal with the connected Trust Switch-In
B
transmitter. (Refer to the transmitter's manual if needed).
The connected lamp will turn ON-OFF-ON-OFF to confirm that the transmitter has been removed.
C
OPTIONAL: RESET START-LINE MEMORY
Warning: This step will remove all paired Start-Line transmitters from the dimmer memory. (Matter will not
be reset by this process).
To reset the Start-Line memory, press and hold the button on the dimmer for 15 seconds until the LED blinks
A
red.
When the LED blinks red, press the button shortly again.
B
The connected lamp will turn ON-OFF-ON-OFF to confirm the reset.
C
10