VEVOR KW1200 Handbuch Seite 9

Winding/unwinding the cable without load
1. Place the ratchet lever in the center position.
2. The cable reel now moves freely in both directions.
3. Pull the cable at the fixed hook until the hook can be attached to
the load to be moved.
4. Wind back the excessive cable by turning the crank clockwise.
Winding up the cable under load (towing, loading)
1.Hold the crank firmly and push gently to relieve the ratchet lever
2.Place the ratchet lever in position.
3.Turn the crank clockwise to evenly wind up the steel cable.
Unwinding the cable under load (lowering, unloading)
1.Hold the crank firmly and push gently to relieve the ratchet lever.
2.Place the ratchet lever in position.
3.The cable should be fully retracted again after use
Ratchet switch
1.There are 3 positions for the ratchet switch: The higher position is for
pulling, the lower position is for releasing, and the middle position is for
both pulling and releasing, but it can only be used when the winch is
loaded. Hold the crank handle tightly if you want to change the switch
position.
2.Before using, install the winch on a firm and flat surface. To install it, put
the ratchet switch in the middle position and pull the cable out until the
holes on the bottom of the base are visible. Then use at least 3 sets of 3/8
inch bolts and locking nuts, in a triangular pattern, to affix the base to the
surface. Use an extra metal or hardwood board when necessary.
3. Then install the crank handle to the axis bolt with nut.
4. Put the ratchet switch in the higher position and turn the crank handle
clockwise to pull. Place the ratchet switch in the lower position and turn the
crank handle counterclockwise to release.
- 8 -