Xblitz RF100 Bedienungsanleitung Seite 11

05. DESCRIPTION
See Fig. 2 on page 2
1. Turn on/ turn off
2. Changing the range of radio waves
3. Changing the mode
4. Select preset station no 1
5. Select preset station no 2
6. Select preset station no
7. Select preset station no 4
8. Select preset station no.
9. Select preset station no
10. Mute the sound
11. Skip 10 tracks back
12. Skip 10 tracks forward
13. EQsetting
14. Turning off the display
15. Automatic saving of a radio station and scanning of presets
radio stations
16. Volume
17. Sound settings
18. Volume +
19. Previous file
20. Play / Pause
21. Next file
06. FAQ
1. No power
- the car's engine is turned off,
- if the power supply for accessories is installed in the car, you can turn the car key to ACCto
provide power to the accessories,
- if the power circuit is burnt, change it,
- if the temperature in the car is too high, lower it and try again.
2. No sound
- if the sound it set to minimum, set it to a proper value,
- improper wiring, improper file format or damaged files on the drive can cause the lack of
sound
3. No radio reception
- if the antenna is not connected properly or the reception is weak, make sure that the
antenna is properly mounted in place,
- if you cannot find any radio stations during an automatic scan, the broadcasting signal can
be too weak for the device to pick it up. Try tuning it manually
4. Wiring diagram
- make sure that the casine is properly grounded. Proper grounding eliminates most issues
with electronic noise. Good grounding of the casing require connecting it to the car's chassis
The area around the connection should be thoroughly cleaned - with no rust, paint, plastic or
dust - for best grounding quality
OF THE
3
5
6
11
PILOT
EN