Werbung
8 OPERATION
Make sure the power cord has been fully unwound before you switch on the machine. The air
leaving the grids must not be hindered.
If the electrical tool has been connected to the electronic outlet, directly switch on the electrical
equipment.
Use the crevice nozzle for vacuuming up dust from narrow and confined spaces.
When vacuuming up liquids, make sure the nozzle is not fully submerged in the liquid to be
vacuumed up.
Clean the machine after use according to instructions and wind the power cord around the
shell.
8.1
Switching on and off
▪
To switch on the machine, set the on/off switch (1) to "I".
▪
To switch the machine off, set the on/off switch (1) to "O" / "=".
8.2
Vacuuming up coarse waste material
▪
Check whether the new advanced dust filter has been fitted.
▪
Mount the tube (11) to the hose (9).
8.3
Vacuuming up small waste material and dust
▪
Check whether the new advanced dust filter has been fitted.
▪
Fit a dust bag.
▪
Mount the tube (11) to the hose (9).
8.4
Vacuuming up dust released from an electrical tool
▪
Check whether the new advanced dust filter has been fitted.
▪
Fit a dust bag
▪
Connect the hose (9) directly to the dust extraction outlet of the electrical tool.
8.5
Emptying the tub
▪
Switch off and unplug the machine.
▪
Remove the motor housing (3).
▪
Empty the tub (6).
8.6
Vacuuming up liquids (Fig 3a)
▪
Check whether the new advanced dust filter and dust bag has been removed.
▪
The sponge filter (17) must be used for vacuuming liquids.
▪
Install the sponge filter (17)
▪
Make sure the inside of the tub (6) is clean and free from dust.
▪
Mount the tube (11) to the hose (9) and fit the wet & dry floor brush.
8.7
Drain function (Fig. 4)
▪
When your tank is full of water, just twist the cover of the drain function to let the water out.
8.8
Blow function (Fig. 5)
▪
Remove dust cover and insert the hose connector into the blowing mouth to use the
blowing function.
Copyright © 2024 VARO
POWX3240
P a g e
| 7
EN
www.varo.com
Werbung
