WALMEC Walcom GENESI CARBONIO 360 HTE CLEAR Bedienungsanleitung Seite 19

Mod. GENESI CARBONIO 360 HTE BASE
TECHNICAL SPECIFICATIONS
6 psi) - Air fitting: G 1/4" M
- Maximum air pressure: 5 bar (73 psi)
N AT 0.7 bar
ø
TEST
0.8
1.0
1.2
1.3
CFM)
1.4
1.7
1.9
2.5
** Product flow was calculated with water, setting the recommended regulations.
USE
or other The GENESI CARBONIO 360 HTE Base series of spray guns has been designed for the application of colours, paints or other
fluid substances.
The instrument is not suitable for use with abrasives or products containing acids or petrol of any kind.
To obtain the best results, the following instructions must be followed carefully:
The instrument is not suitable for use with abrasives or products containing acids or petrol of any kind.
1. When possible, use an air hose with a minimum internal section of ø 10 mm (0,37").
2. Make sure water, oil or other impurities are fully filtered from the compressed air used (for example, by installing a
Walcom FSRD3/4 filter unit or the most complete and efficient Walcom TD3 PRO multifunction heat conditioner).
ADVICE FOR CORRECT USE
7.9"). 1. The distance between the spray gun and the surface to be painted must be set between 150 and 200 mm (5.9 - 7.9").
ity. If the spray gun is working at a too low pressure and at a too high distance, it will not perform to the best of its capacity.
2. The jet from the spray gun must always be perpendicular to the
surface being painted and the paint must be applied in horizontal
strokes. Any eventual shift from this position when spraying will
result in an uneven application of the paint layer.
3. Correct viscosity of the paint is between 15 and 25 sec. Ford
cup n°4. These values depend on the application and the nozzle
size used.
SHAPE OF THE FAN
ar jet
Adjust the air pressure, product quantity and spray opening
until obtaining a regular imprint as in fig. C
istruzioni WI34_18.indd 19
** PRODUCT LOAD (3.5 turns)
FEED
111 Gr/min. (3.9 oz/min.)
Gravity
Gravity 155 Gr/min. (5.5 oz/min.)
244 Gr/min. (8.6 oz/min.)
Gravity
Gravity 260 Gr/min. (9.2 oz/min.)
Gravity 290 Gr/min. (10.2 oz/min.)
370 Gr/min. (13 oz/min.)
Gravity
Gravity 420 Gr/min. (14.8 oz/min.)
490 Gr/min. (18.2 oz/min.)
Gravity
RECOMMENDED AIR PRESSURE: 2 bar (29 psi)
At the recommended air pressure the spray gun works with at transfer efficiency superior to 65%.
- Air pressure too low
- Product viscosity too high
- Quantity of product too high
ADJUSTMENTS
- Working pressure: 1,5-2,5 bar (22-36 psi)
- Fan: Fully open
- Product: 3,5-5 turns
FAN DIMENSIONS AT 20 cm (7.9")
19 cm (7.5")
23 cm (9.1")
27 cm (10.6")
29 cm (11.4")
28 cm (11")
32 cm (12.6")
31 cm (12.2")
33 cm (13")
- Air pressure too high
- Product viscosity too low
- Quantity of product too low
19
AIR CONSUMPTION AT 2 bar -27 psi
350 l/min (12.4 CFM)
- Regular jet
09/01/18 14.18