Werbung
Verfügbare Sprachen
Verfügbare Sprachen
lubrication
fig.' 3
6.Put the spindle away a distance in the diection of the bow(see fig.6)
7.1n amoderate
8.Spindle rotating foward
spindle tube wall evenly.(see fig.8)
9.Hold down the main shaft rubber,using
and propeller (see fig.9)
10.Load the motor seat module (see the fig. 10)
1 1Lock the motor seat screw(see fig. 11)
12.To reconnect the cooling rubbes hose(see fig. 12)
13.To reconnect the motor wire(see fig. 13)
NB: 1*Battery wire exhausts to boat side to prevent the wire being cut off by the
steering wheel.
2All plug need to be tight.
3.Ensure the cabin cover tight to prevent leakage.
oil on the spindle
1.Put out the motor wire(see fig. 1)
2.Put out the cooling rubbes hose(see fig.2)
3.Screw out the motor seat screw(see fig.3)
4.Remove
the motor seat module
5.Hold down the main shaft rubber pieces,using
wrench lockout and propeller(see
amount of lubrication oil to the tail of the spindle tube.(see fig.7)
and backward,pulls
tube wall
(see fig.4)
fig.5)
slowly,let the lubrication oil on the
a wrench tightened the screw down
English
a
Werbung
