TecTake 402997 Installationsanleitung Seite 2

G
G
Handset Regulating Control Box Operation Instruction
Modify the Displayed Minimum Height
When the displayed height does not match the actual height, adjust the displayed
minimum height to the actual height.
1.Simultaneously press the "M" and "▲" button for 3 seconds to modify the diplayed
minimum height.
2.When the number starts twinkling, press the "▲"or "▼" button to increase or decrease
the minimum height accordingly. Then press the "M" to save the modifiction. The buzzer
will beep twice, indicating the save is successful
3.Repeat above steps to modify repeatlly.
Set lower limit height and upper limit height of standing desk
1. Set Lower Limit Height
Adjust the standing desk to the desired height, simultaneously press the "M" and "1"button
for 3 seconds. The buzzer will beep twice, indicating the set is successful. Then the desk
can not move to a lower position lower than the setted lower limit height.
2. Set Upper Limit Height
Adjust the standing desk to the desired height, simultaneously press the "M" and "2"button for 3 seconds.
The buzzer will beep twice, indicating the set is successful. Then the desk can not move to a higher position
than the setted upper limit height.
3. Remove Lower Limit Height and Upper Limit Height
Simultaneously press the "M" and "▼"button for 3 seconds to remove the recorded lower and upper limit
height. The buzzer will beep twice,indicating the set is successful.
Anti-collision sensitivity adjustment - optional features:
a. Press and hold the" " " "button for 5 seconds at the same time to switch the sensitivity,
Switch one file for 1 time and divide it into 4 files (A-3, A-2, A-1, A-0);
b. The display shows " ", the anti-collision function is off; the display shows " ", low sensitivity; Display
shows " ", medium sensitivity; display shows" ",high sensitivity; (factory default is A-2);
c. During height adjustment, when tabletop comes in contact with another object, it instantly stops and reverses
to avoid damage.
d. Press and hold the " " " "button for 5 seconds at the same time. If the display does not display the above
code, there is no anti-collision function.