Specifications; Operation - Elma Instruments Sagab 902 Bedienungsanleitung

Specifications

Electrical Specifications
Function
DC Voltage
AC Voltage
40-400Hz
Resistance
Max input voltage
Diode Test
Continuity Check
Display
Over range indication
Polarity
Low Battery Indication
Input Impedance
AC Response
ACV Bandwidth
Auto Power Off
Batteries
Operating Temperature 32ºF to 104ºF (0ºC to 40ºC)
Storage Temperature
Weight
Size
Standard

Operation

AC/DC VOLTAGE MEASUREMENTS
CAUTION: Do not measure AC/ DC voltages if a motor on the circuit is being switched
ON or OFF. Large voltage surges may occur that can damage the meter.
1. Set the function switch to the ACV position to measure AC voltage or in DCV to
measure DC voltage.
2. Touch the black test probe tip to the negative side of the circuit.
Touch the red test probe tip to the positive side of the circuit.
3. Read the voltage in the display
Sagab by Elma 902
Range
200mV,
2.000V, 20.00V, 200.0V, 600V
2.000V, 20.00V
200.0V, 600V
200.0Ω
2.000k Ω, 20.00kΩ, 200.0kΩ
2.000MΩ
20.00MΩ
600V AC/DC
Test current 1mA max., open circuit voltage of 1.5V typical
Audible signal if the resistance is <150Ω
2000 count 3 -1/2 digit LCD
LCD displays "OL"
Minus (-) sign for negative polarity.
"BAT" symbol indicates low battery condition.
>7.5MΩ (VDC & VAC)
Average responding
50Hz to400Hz
15 minutes (approximately)
Two 1.5V AAA
14ºF to 122ºF (-10ºC to 50ºC)
145g
104x55x32.5mm
IEC1010 CAT III 1000V, CAT IV 600V Pollution degree II, CE
Approved
Accuracy
0.5% rdg + 3d
1.2% rdg + 3d
1.0% rdg + 8d
2.3% rdg + 10d
0.8% rdg + 5d
1.2% rdg + 5d
5.0% rdg + 5d
10.0% rdg + 5d
25