Setting The Current Time - Ferplast Risto Pet Gebrauchsanweisung

Function of buttons (refer to image I on page 5)
Button
MANUAL DISPENSING button
LOCK/BACK button
OK/SET button
Button -/+
Note: To reset the dispenser, unlock the control panel by pressing the UNLOCK/ BACK button for 3 seconds, then simultaneously press
the UNLOCK/ BACK and OK/SET buttons for 3 seconds until all icons on the screen are visible. The reset will be complete.

Setting the current time

Note: The food dispenser can only function properly if the clock is correctly set to the current time.
1 After switching on the dispenser, press and hold the OK/SET button for about 3 seconds; when the hour digit flashes, press the -/+ button to set the
hour and then press the OK/SET button to confirm.
2 The minutes digit flashes: press the -/+ button to set the minutes and press the OK/SET button to confirm.
3 The AM icon flashes: press the -/+ button to choose AM or PM, press the OK/SET button to confirm. Clock adjustment is now complete.
Scheduling of meals
1 Setting the feeding time.
After setting the current time, you can set the feeding time for the first meal.
The meal number 1 and the hour digit flash simultaneously (J1): press the -/+ button to set the time for the first meal, press the OK/SET button to
confirm.
The minutes digit flashes together with the meal number (J2): press the -/+ button to set the minutes for the first meal and press the OK/SET button
to confirm.
AM flashes together with the meal number (J3): press the -/+ button to set AM or PM.
2 Setting the feeding portion.
After setting the feed time, the feed portion of the first meal can be set.
The number of meal 1 and the digit of the portion flash simultaneously (J4): press the -/+ button to set the feed portion of the first meal, then press
the OK/SET button to confirm.
The feed plan for the first meal is now set. Repeat the above steps to set the other meals (2 to 6)'.
Notes
• Up to 6 meals can be set.
• The maximum portion per meal is 16 units.
Maintenance
• Remove the batteries or disconnect the power supply.
• Remove the food tank, the stainless steel bowl and its holder from the main body of the dispenser following the installation steps (H-A) in reverse order.
CAUTION: Before removing the tank, make sure it is completely empty. If not, empty the remaining kibble into an external container.
• Wash the tank, steel bowl and bowl holder with water and neutral detergent, taking care to rinse them thoroughly to remove all detergent residues.
• To prevent moisture from forming in the food tank, make sure it is perfectly dry before reassembling it and filling it with kibble.
• DO NOT WASH the main body of the dispenser with water as it contains electronic components. Clean it with a dry or slightly moistened cloth.
Troubleshooting
Problem
Buttons do not work
I do not remember the meal setting
Function
Press once to dispense one portion, press several times to dispense many.
In the locked state, press and hold for 3 seconds to unlock.
In the unlocked state, press and hold for 3 seconds to lock.
In the unlocked state, press once to return to the last step.
In the unlocked state, press and hold for 3 seconds to start setting the current time and feeding schedule;
press once to confirm the setting and move on to the next step.
After setting the plan, press and hold for 3 seconds to finish setting.
Press -/+ to check meal settings. During meal programming, press -/+ to set the value.
Solution
Press and hold the unlock button for 3 seconds to enter setting mode.
In the locked state, press + or - to check the settings for each meal.
English 7