Alesis TRANSACTIVE 400 Benutzerhandbuch Seite 3

User Guide En lish
1. Make sure all items listed
the box.
READ SAFETY INSTRUCTION
2.
THE PRODUCT.
3. Study the connection diagram.
Make sure all input devices such as microphones, CD players,
4.
and linked amplifiers/PAs
are set at "zero."
Switch everything on in the following order.
5.
i. audio input sources (i.e. microphones, instruments, CD Players)
ii. TRANSACTIVE 400
iii. any additional amplifiers
6. When shutting down, always reverse this operation by turning off:
i. any additional amplifiers
ii. TRANSACTIVE 400
iii. audio input sources (i.e. microphones, instruments, CD Players)
Support
For product registration, visit alesis.com
For the latest information about this product (system requirements, compatibility information, etc.), visit
alesis.com/transactive-400
For additional product support, visit alesis.com/support.
Connection Diagram
HEADPHONES
A-a.sjs
Important:
• With all speakers, an initial "break-in" period is needed to perform at optimal levels. To properly "break-
in" your TRANSACTIVE 400, play an audio source at medium volume for a few hours.
For best audio quality, avoid using this device in a high RF-radiated environment.
in the Box Contents are included
BOOKLET BEFORE USING
are turned off and volume settings
POWER
CD PLAYER, ETC.
DRUM MODULE
3
in
Box Contents
TRANSACTIVE 400
Power Cable (standard IEC)
User Guide
Safety & Warranty Manual
Any items shown here but not mentioned in
the Box Contents are sold separately.
(additional TRANSACTIVE 400
MIXER
sold separately)