Starlyf CLIMATE CONTROL Bedienungsanleitung Seite 8

If you press the ON/OFF button a second time the unit will switch off after 20 seconds.
Select the desired temperature: use the button (2) to increase the temperature and (3) to decrease the
temperature.
Pressing button: (4) once will switch the unit to heat mode. Pressing it a second time will operate the fan.
The LED light (6) will light up if the unit is being used in fan mode.
NOTE: In fan mode: No cold air is emitted; the fan works at room temperature and therefore moves the
ambient air.
The level up and level down buttons only work for the heating programme.
Starlyf® Climate Control has a built-in timer that automatically switches off the unit after a set period of time.
If you want to use the timer, with the unit switched on and plugged in, press the timer button (5) to activate the timer:
Press the timer button until you reach the number of hours you want to elapse before the appliance swit-
ches off. You can choose between 1 hour, 2 hours, 3 hours, 4 hours and 6 hours.
When the timer function is in use, the light (7) will light up.
When you finish using the appliance, click the /ON/OFF button and unplug it from the mains. Store it in a
cool and dry place until next use.
Note: The appliance will stop heating when it reaches the selected temperature.
(See picture C)
USE OF THE REMOTE CONTROL
(See picture D)
Click the ON/OFF button (1) and the appliance switches on in heat function. If you press the button a
second time, it will switch off in 20 seconds.
If you want to use it in fan mode, click the button: fan function (2).
Press button (3) to increase the temperature; if you wish to lower the temperature, press button (4).
If you want to switch from fan mode to heat mode click the button: heat function (5)
If you want to use the timer press button (6): and select the desired time: 1 hour, 2 hours, 3 hours, 4
hours, 6 hours.
MOUNTING THE REMOTE BRACKET
(See picture E)
With 3M adhesive tape (included):
Peel off the bracket and place it adhesive side down on the back of the bracket. Press for a few seconds.
Peel off the other side and place it on the desired smooth surface. Press the holder firmly onto the surface
for a few seconds.
Use the screws/anchors (included):
Insert each screw into the openings on the remote control bracket. Tighten them with a screwdriver to
secure them.
REMOTE CONTROL BATTERY INSTALLATION
See picture F)
The remote control is powered by a CR2025 battery which is included (and installed in the remote control).
When the battery is flat and needs to be replaced, please follow the steps below:
1. Simply pull out the battery compartment tray to open the battery compartment.
2. Insert a one new 1 CR2025 battery with the positive '+' side facing up.
3. Once the battery is inserted, push the tray back in until it is fully inserted.
4-CLEANING AND MAINTENANCE
ATTENTION: Before starting any maintenance, unplug the Starlyf® Climate Control and allow it to cool down comple-
tely.
Use a damp, non-abrasive cloth to clean the exterior. If necessary, use a mild detergent. Wipe dry with
a soft cloth.
CAUTION: DO NOT ALLOW LIQUID TO ENTER THE HEATER.
Do not use alcohol, petrol, abrasive powders, furniture polish or rough brushes to clean the heater. This
could damage the casing of the product.
Do not immerse in water.
-Wait until the appliance is completely dry before using it.
-Store the heater in a cool, dry place when in use.
Warning: If the appliance stops working due to overheating, unplug it from the wall socket and plug it in again.
8