Using The S-Bus Output; Related Servonaut Products; Declaration Of Conformity; Safety Notes - Servonaut Rm6+ Bedienungsanleitung

Attention: This setting has no effect if the
receiver is turned on in bind-mode
(jumper is not plugged in)!

Using the S-BUS output

To use the S-BUS output it has to be
activated using the CARD feature of the
RM6+. The S-BUS signal is emitted on
output SERVO 6.
The servo channel 6 is only available
through the S-BUS in this case. Chan-
nels 1-5 can be used though the connec-
tor and the S-BUS

Related Servonaut Products

TastB
• bind push button
• can be used instead of the jumper for
easier binding of the model
RM-T
• temperature sensor for connecting to
the receiver
• is used instead of the jumper. For
binding the sensor has to be discon-
nected

Declaration of Conformity

Hereby, tematik GmbH declares that the
radio equipment type RM6+ is in compli-
ance with Directive 2014/53/EU. The full
text of the EU declaration of conformity is
available at the following internet address:
http://www.servonaut.de.

Safety Notes

Do not expose the module to water or oil.
Do not cover it with foam. Disconnect the
battery immediately after use. Do not con-
nect the battery with wrong polarity. Avoid
any short circuits. Always use caution
when connecting the battery. Always turn
on the transmitter first.

Warranty Information

Warranty is granted for one year from date
of purchase. This warranty does not cover
damage due to incorrect handling or wir-
ing, over voltage or overloading. This war-
ranty does not cover consequential,
incidental or collateral damage under any
circumstances. By the act of using this
product the user accepts all resulting liabil-
ity.
Subject to change without notice.
10/2024 Software V1.0
28