Multibus Output; Parking Your Model - Servonaut Rm6+ Bedienungsanleitung

MultiBus output

With the RM6+ for the first time a
Multibus/Multiswitch module can be
used with a Servonaut 6 channel
receiver. As with the bigger receivers
the output is compatible with all
Servonaut modules
interface as well
Robbe/Futaba
Multiswitch/MultiProp modules.
To use the Multibus it must be active in
the radio when binding the receiver like
with the other Servonaut receivers. The
RM6+ only supports
channel 8. The signal is emitted on the
output SERVO 5. The servo channel 5
is not usable on the RM6+ in this case!
If the RM6+ is used as a slave receiver
without the Multibus
deactivated using
functionality of the receiver - see section
„Settings with the Servonaut Radio
HS12/HS16" starting on page 26.
with Multibus
as with most
and Graupner
Multibus on
it can be
the CARD

Parking your Model

With the RM6+ you can alternate driving
one of four of the saved models without
having to switch them on/off by hand
(using a Zwo4 plug-in it is three).
A (master)receiver that is in parking just
stops sending signals to the servos and
connected electronics.
The battery voltages of all four models
are monitored in the background. A
warning is displayed on the radio HS12
or HS16 if the voltage falls below a
certain value (can be configured on the
radio).
Important: Before driving check how
the other electronics in your model react
to the servo signals being switched
on/off.
20