Channel Deactivation; Your Setup: Zwo4 Plug-In And Rm6 - Servonaut Rm6+ Bedienungsanleitung

You can't use a slave without a master
receiver. Master and slave behave dif-
ferent when you switch to another mod-
el: The master receiver stops sending
signals to the servos. The slave receiver
will continue sending the last signals it
received. You can't use an older Servo-
naut E9 or E18 as a slave receiver.
Please note: The battery moni-
toring only works with the mas-
ter receiver.
Attention: There can not be more than
one master receiver for each model.

Channel deactivation

To protect the servos and save energy
the RM6+ supports deactivation of all
channels when using a Servonaut radio
HS12 or HS16. The deactivation is con-
figurable with the HS12 and HS16 in the
channel servo menu. Please note: De-
activating only disables the signal - it
does not disconnect the servo from the
BEC voltage. If you use digital servos
please check how they react to a disa-
bled signal beforehand.
Your Setup:
Zwo4 plug-in and RM6+
Model Handover
With the RM6+ it is possible to take
turns driving one model - with two radi-
os. Both radios have to be bound with
the receiver (see chapter Binding).
Please note that only one radio can
have an active connection to the RM6+
(LED of the RM6+ off or flickering when
a channel value changes).
The second radio can select the receiv-
er if the first connection is stopped.
Switch the level or the model with your
radio. Don't switch the radio off, the
handover will take much longer.
Tip:
If the receiver doesn't respond despite
green indicator on the radio, check the
level switch of your radio.
22