FDS OP70052 Bedienungsanleitung Seite 8

SET-UP
● Check the ground where the product will be set up for any sharp
objects or debris. Do not install the product over concrete or any
hard surface.
● Place the product on a soft level surface at least 2 meters from
any structure or obstruction such as a fence, garage, and house;
overhanging branches, laundry lines or electrical wires.
● Ensure the play area is free from hazards such as furniture,
walls, sharp objects, other hard surfaces, etc.
● Set up the product away from water and any potential fire
hazards.
● Keep the blower (air pump) and power cord away from areas of
water and moisture. If water contacts the blower (air pump),
unplug the blower (air pump) power cord. Do not operate until the
blower is completely dry.
● Remove the product from the carry bag. If any, ensure the slide
cover coming with the product stretches well from top to end. Be
sure to place as close to the power source as possible.
● Stretch the inflation tube and attach it to the end of the blower
(air pump). Ensure the inflation tube is securely attached and in
good condition. The inflation tube should be straight and
untwisted. Reposition the blower (air pump) if necessary.
● If the product comes with water bags, please follow the
undermentioned instruction, otherwise, overleap this point.
Spread out the product, place and fasten the empty water bags at
the two sides of the product. Open the stopple and fill water in the
water bags until 80% full (about 22kg), push and close the
stopple. Make sure water bags are firmly attached on the product
and no water leakage before the product is fully inflated, and
never allow children to play on the slide without installing water
bags. (refer to picture A)
14
● Push ground stakes through blower base holes. You may need
to use a hammer for proper placement.
● Make sure the blower (air pump) power switch is in the OFF
position. Ensure the power connections are safely sited and
tripping hazard is minimized.
● Place the inflation tube onto the blower(air pump) and place the
long end of the strap through the loops. Wrap the strap around
the inflation tube and feed it through the black loop. (refer to
picture B). Pull the strap tightly and secure the reverse side to the
black loop and affix it to the hook & loop fastener. Adjusting the
direction of the inflation tube to prevent bends or distortion that
may impede the flow of air. (refer to picture C)
● The blower (air pump) should be securely sited and affixed to
the ground before use. Plug the blower (air pump) into an
approved grounded outlet.
● Ensure the blower (air pump) is free from debris and securely
sited to avoid tripping.
● Turn the blower (air pump) power switch to ON. The continual
air-flow blower (air pump) must be left ON at all time while the
product is being used. (refer to picture D)
● The product should be fully inflated.
● Ground support stakes are used for lawn ground surfaces. Hook
and fit each provided ground stake through each loop in the
bouncer. To prevent overturn or lift during playing, push stakes
firmly into the soil. Make sure the hooked end of the stake is over
the loop. The stakes should be placed level with or under the
ground in order to reduce tripping hazards. (refer to picture E)
● Please check the age recommendation and user weights
(printed on the product). You must not exceed the total weight for
the product.
● Put the included play accessories if any for playing into the
product. (refer to picture F, G)
15