EASYmaxx SL-01S Gebrauchsanleitung Seite 3

EN
Dear Customer,
We are delighted that you have chosen our roof gutter solar
lights. If you have any questions, contact the customer service
department via our website: www.ds-group.de/kundenservice
Information About the Operating Instructions
Before using the article for the first time, please read through these
operating instructions carefully and keep them for future reference
and other users. They form an integral part of the article. The manu­
facturer and importer do not accept any liability if the information in
these operating instructions is not complied with.
Intended Use
• The solar lights are attached to a roof gutter in order to illumi­
nate the area around the house. Their battery charges up in
daylight via the solar panel. This stored energy allows the LEDs
to glow in the dark.
• The articles are for personal use only and are not intended
for commercial applications. The article should only be used
as described in the operating instructions. Any other use is
deemed to be improper.
• The following are excluded from the warranty: all defects
caused by improper handling, damage or unauthorised at­
tempts at repair. This also applies to normal wear and tear.
Safety Notices
■ Keep the packaging material away from children and animals.
There is a danger of suffocation!
■ The articles are not a toy! Keep children and animals away
from the articles in order to prevent injuries.
■ Never look directly into the light beam! There is a danger of
dazzling!
■ Do not take the articles apart (except to remove the battery
before disposing of the solar unit). Do not try to repair it
yourself or to replace any individual parts. In the event of any
damage, contact the customer service department.
■ If the battery has leaked, do not allow your skin, eyes and
mucous membranes to come into contact with the battery acid.
There is a danger of burns from battery acid!
If you touch battery acid, rinse the affected areas with abun­
dant clear water straight away and seek medical assistance
immediately.
■ Batteries must not be taken apart, thrown into a fire, immersed
in liquids or short­circuited.
■ Do not drop the articles or allow them to be knocked violently.
■ Do not use the articles if they have visible signs of damage.
■ Never immerse the articles in water or other liquids! They are
only protected against splashing.
■ The articles should not be placed near to other light sources
such as street lamps or other lamps so that the LEDs can be
switched on automatically.
■ If you do not intend to use the articles for a prolonged period
of time, switch off the solar units and store the articles in a dry
place.
■ Keep the solar panel clean so that the greatest possible
absorption of light is ensured. Wipe down the solar panel (and
if necessary also the remaining components of the article)
with a damp cloth. Never use any caustic or abrasive cleaning
agents. These may damage the surface.
Technical Data
Article number: 03612
Model No.: SL­01S
Power supply: 1,2 V DC (1x Ni­MH battery, AA type,
1200mAh)
Battery charge time: approx. 6 – 8 hours (in sunshine)
Lighting time: up to 8 hours (with a fully charged battery)
ID (operating
instructions): Z 03612 M DS V3.1 0724 as
Items Supplied
3x solar lights (incl. battery)
3x locking screws
1x operating instructions
Check the items supplied for completeness and the article for
transport damage. If you find any damage, do not use the article
but contact our customer service department.
Remove any possible films, stickers or transport protection from the
article. Never remove the rating plate and any possible warnings!
Article Overview
From Above
1
2
3
1 Solar panel
2 Solar unit
3 Locking screw
4 Fastening arm
Putting Into Operation
L
Before the LEDs can light up, the batteries of the solar
units need to be charged up for around 6 to 8 hours
depending on the angle of the sunlight.
Do not put up the solar lights in the shade (e.g. not below
treetops). If possible, they should be able to receive direct
sunlight all day long.
1. Pull out the protective strip next to the LEDs to activate the
battery.
2. Slide the On/Off switch to ON.
3. Hook the fastening arm onto the
4. Tighten the locking screw until the
Gutter
5. Repeat steps 2 to 5 for the other solar lights.
The batteries of the solar units can now charge up in daylight.
When darkness sets in, the LEDs automatically switch on. When it
gets light, the LEDs switch off and the batteries are charged up via
the solar panels.
Operating Instructions
From Below
5
4
7
5 ON / OFF On/Off switch
6 LEDs
7 Battery compartment
edge of the gutter.
solar lamp is held firmly in place.
It must not wobble.
6