Delphi LS7002-S Bedienungsanleitung Seite 5

The shears comply with IEC 745 safety
standard and are double insulated. The
performance of the shears is better than that
specified in national standards, making the
shears a kind of safe and efficient tools for
cutting various thin sheets.
These products are powered by 220V.
single-phase AC 50Hz.
Before operating the tools, please read this
manual carefully so that you can
successfully operate and use the shears.
Technical Specifications
Model: GPE-5301
Input power: 850W
Max steel cutting capacity: 2.5mm
Minimum cutting radius of curvature: 45 mm
Cutting speed: 90r/min
Stroke speed at full load: 2200/min
Maximum cutting capacity means the
maximum thickness of cut steel sheet with
tensile strength of 390 N/mm2. The
maximum cutting thickness should be
modified as follows:
Model: GPE-5301
Thickness: 1.0, 1.6, 2.0
Tensile strength: 800 N/mm2
1
2. APPLICATION, INSTALLATION AND ADJUSTMENT OF
THE SCISSORS.
When using shears to cut sheet metal of various shapes and
various geometric shapes, the steels will deform slightly and
be of good quality. Especially for elements that cannot be cut
with cutting machines or by hand, scissors have more
advantages. The advantages of these tools are easy
operation and portability, high efficiency, low labor intensity
and savings on the customer's investment.
Before starting work, check whether the voltage of the power
source matches the nameplate.
When cutting, the tool should be positioned parallel to the
surface of the cut object. The fork of the cutting tool should
be aimed at the position of the workpiece and then move the
tool forward. Overall, cutting is smooth. If the distance
between the two blades is incorrectly set, the tool may jam.
In this case, first turn off the tool and then adjust the gap as
recommended. Be careful never to force the tool, otherwise
the cutters etc. may be damaged.
When installing and adjusting cutters, first disconnect the tool
from the power source. Mix the fittings so that the distance
between the 2 cutters is as large as possible, then adjust the
position of the 2 cutters so that their pointed ends overlap
each other by approximately 0.1 to 0.0 mm. Then screw in
the cutter mounting screws and then screw in the set screws
to press them against the top of the 2 cutters to prevent them
from moving.
the gap between the 2 knives should be set to approximately
0.36 mm, and when cutting a sheet of metal with maximum
thickness, the gap should be approximately 0.3 mm: L=0.2XT
Where:
L is the length of the slot in millimeters;
T is the thickness of the steel sheet in millimeters.
The formula applies only to steel sheets with a tensile
strength of 390 N/mm2. For other steel sheets, the value
must be changed. In general, the value of L should be
smaller for soft and durable sheets and larger for hard and
brittle sheets
2