Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Notes:
•
If your pairing device gets switched off or gets manually disconnected, the sound bar will auto-
matically enter pairing mode.
•
A successful connection will be re-established with the already paired device(s) once you re-enter
wireless range (10m). To connect to other devices, repeat the above pairing steps.
•
There is no automatic shutdown in pairing mode. The sound bar will remain in pairing mode even
if no device is paired, so switch off if not in use.
Aux In Mode
•
Requires a 3.5mm audio cable (not included).
1.
Connect a 3.5mm audio cable to the Aux In on the unit and the audio output/headpho-
ne jack on an audio device.
2. Power on the soundbar and press MODE button to select AUX Mode.
3. Use the controls on the connected device to select and play audio. Be sure the volume
on your connected device is audible when you begin playing.
•
HDMI IN Mode(Blu-ray DVD player, cable box, satellite box, etc.)
1.
Power on the soundbar and press MODE button to select HDMI Mode.
2. Connect the HDMI HD cable to the TV eARC or ARC jack, and the other end to the "HDMI
OUT" jack on the back of the soundbar. And then connect another HDMI HD cable to
the Blu-ray DVD player, cable box, satellite box, etc., and the other end to the "HDMI
IN" jack on the back of the soundbar. Turn on the TV with TV remote control can also
turn on the soundbar, select signal source with TV remote control, enter into opera-
tion screen of Blu-ray DVD player, cable box, satellite box, etc., choose the sources to
playback with their remote control.
•
HDMI OUT Mode (HD music decoding playback)
1.
Power on the soundbar and press MODE button to select eARC/ARC Mode.
2. Connect the HDMI HD cable to the TV eARC or ARC jack, and the other end to the "HDMI
OUT" jack on the back of the Soundbar. Turn on the TV with TV remote control can also
turn on the soundbar, directly detect the digital signal transmitted by the TV to decode
and restore the music playback.
•
Optical In Mode
Requires an audio source with an Optical Audio Output and a Digital Optical Audio Cable
1.
Using a Digital Optical Audio Cable, connect the Optical Input on the soundbar to the
Optical Output on your audio source (TV, amplifier, etc.)
2. Power on the soundbar and press MODE button to select OPT Mode.
3. On the connected audio source (TV, amplifier, etc. ), be sure the audio settings are set
to PCM or Optical Audio.
4. Audio played through the connected audio source (TV, amplifier, etc.) should now be
heard through the speaker.
USB Mode
•
After Power on, connect a USB driver directly into the USB jack, short press the MODE bu-
tton on the soundbar or remote control to select USB mode, and start playing music from
the USB driver.
EN
|
9
Werbung
