Nilait NI-SOUNDBSU-200ATM Benutzerhandbuch Seite 8

EN
Connecting the Wireless Subwoofer
Power on the soundbar. Indicator of subwoofer will be white flash after connecting to power.
Press twice the PAIR button on subwoofer with white indicator flashes fastly(under pairing sta-
te). Then press "MODE" button on soundbar for about 3 seconds, then the indicator of subwoo-
fer will be solid red after about 30 seconds, it means paired successfully between soundbar and
subwoofer.
Select Modes
Press the MODE button on the soundbar or on the remote control to select the BT, AUX, OPTI-
CAL, HDMI in, HDMI Out, USB mode. The selected mode will show on the display.
Bluetooth Mode
•
Turn on the sound bar and then short-press the MODE button to select BT mode and
LED display "BT" on the sound bar will flicker in the Bluetooth pairing mode.
Activate the pairing function on your phone or other compatible device & select
"NilaitH200ATM" for BT connection.
1. When successfully paired, you will hear a tone and LED display stops flickering.
Then music on your phone or other compatible device that you selected can be
played on the sound bar.
2. You can use the volume buttons on the sound bar or on the remote controller to
adjust the volume to your requirements
3. Short press "
or next song.
4. To disconnect, long press the "
another mobile phone device can be used to connect Bluetooth playing; If the
connection is not selected, the soundbar will be on waiting for connection status.
|
8
Remarks:
1. The satellite speakers and subwoofer have been
connected to soundbar in default. User just need
to power on the whole sets to start using.
2. When satellite speakers are in lower power. Plea-
se use the Type-c charging cable to connect the
5V/1A adapter to charge. During the charging
process, the red indicator light is on, and the red
indicator light is off when fully charged.
" to play and pause music. Short press "
" button on the remote control., At this time,
" or " " to previous