National Cycle CRUISELINER SB009 Installationsanleitung

Parts List
Index Description
1 Screw Hex M10-1.25 x 65
2 Screw Hex M8 x 65
3 Bushing, 1 3/16" L x .343 ID w/shoulder 2
4 Frame, Right
5 Frame, Left
INSTALLATION
1. Loosen all six fender rail screws.
2. Remove the front and rear screws from one side.
3. Position mounting bracket, start front screw, M10-
1.25 x 65
4. Position spacer into pocket at rear hole, start M8-
1.25 x 65 screw through mount bracket and spacer
then into fender.
5. Repeat on other side.
6. Tighten to: M8= 22 ft-lbs rear, M10= 29 ft-lbs
middle and front
INSTALLATION OF SADDLE BAG TO FRAME
Rest the stainless steel clips attached to the outside of the bag to the lower section of the frame.
Engage the quarter turn fastener to the frame. Push in and turn clockwise one quarter turn. There
will be a slight spring pressure against the fastener, turn until it stops. Grab the side of the bag,
wiggle it. The bag should be firmly set. If fastener is loose, repeat installation of bag to frame.
Saddlebag Care: Wash with a mild soap or detergent and warm water. Use a
soft cloth. To remove tar use naphtha or turpentine.
Painting: Lightly sand the surface with 600 grit sandpaper and spray lacquer,
urethane or other paint.
Replacement Parts: Contact National Cycle, Inc
Not to exceed 11 lbs (5kg) weight per bag. Do not exceed 80 mph (129 kph) when saddlebags are mounted.
On some motorcycles, additional accessories can reduce a motorcycle's stability and safe operating speed. Never ride a motorcycle that
exhibits any unsafe handling characteristics. Remove all accessories and cargo at once. Have your dealer diagnose and solve the prob-
lem before remounting your accessories.
©2001 National Cycle, Inc. PO Box 158, Maywood, IL 60153-0158 USA
708-343-0400 / Fax: 708-343-0625 / www.nationalcycle.com / e mail: info@nationalcycle.com
Qty.
2
Tools Needed
2
Hex Key Wrench 6mm
Hex Key Wrench 8mm
1
1
English Page 1 of 2
INSTALLATION INSTRUCTIONS
Cruiseliner Saddlebag Kit SB009 and SBC009
for HONDA® VTX1800 C/S
Kit SBC012 for HONDA® VTX1300 C
3
4
1
2
Turn Fastener
clockwise one
quarter turn.
Rest clip on
lower section
of frame
10-111009-000 09/03