National Cycle CRUISELINER SB302 Installationsanleitung

Parts List
Index Description
1 Saddle Bag Frame Mount, Right
Saddle Bag Frame Mount, Left
2 Screw, M8x55 Socket Head
Remove the screws from one Fender Strut.
(Hex Key Wrench, 5mm)
Hold Backrest Side Support in place (if
Backrest is to be installed.)
Hold appropriate Saddlebag Mount in place at
Fender Strut.
Thread M8 x 55 Screw (2) through front bushing,
Fender Strut, and into Fender.
Thread M8 x 55 Screw (2) through rear bushing,
Backrest Support (if used), Fender Strut, then
into Fender.
Tighten the rear Saddlebag Mount screw to 22
ft/lbs (3.0m-kg) (Hex Key, 6mm).
Repeat on other side.
Not to exceed 11 lbs. (5kg) weight per bag. Do not
exceed 80 mph (129 kph) when saddlebags are
mounted.
On some motorcycles, additional accessories can
reduce a motorcycle's stability and safe operating
speed. Never ride a motorcycle that exhibiits any
unsafe handling characteristics. Remove all
accessories and cargo at once. Have your dealer
diagnose and solve the problem before remounting
your accessories.
708-343-0400 Fax:708-343-0625 E - M a i l : i n f o @ n a t i o n a l c y c l e . c o m W e b : h t t p : / / w w w . n a t i o n a l c y c l e . c o m
Qty.
1
1
4
Rest clip on
lower section
of frame
Turn Fastener
clockwise one
quarter turn.
NATIONAL CYCLE, INC.
PO Box 158, Maywood, IL 60153-0158 USA
E n g l i s h P a g e 1 o f 2 , G e r m a n S e i t e 2 o f 2
CRUISELINER SADDLEBAG
INSTALLATION INSTRUCTIONS
Yamaha V-Star Classic
Installation Kit SB302
Tools Needed
Hex Key Wrench, 5mm
Hex Key Wrench, 6mm
2
1
INSTALLATION OF SADDLE BAG TO FRAME
Rest the stainless steel clips attached to the out-
side of the bag to the lower section of the frame.
Engage the quarter turn fastener to the frame.
Push in and turn clockwise one quarter turn. There
will be a slight spring pressure against the fasten-
er, turn until it stops. Grab the side of the bag,
wiggle it. The bag should be firmly set. If fastener
is loose, repeat installation of bag to frame.
Saddlebag Care: Wash with a mild soap or deter-
gent and warm water. Use a soft cloth. To remove
tar use naphtha or turpentine.
Painting: Lightly sand the surface with 600 grit
sandpaper and spray lacquer, urethane or other
paint.
Replacement Parts: Contact National Cycle, Inc
2
1 0 - 1 1 1 3 0 2 - 0 0 0 0 5 / 0 2