Troubleshooting - Tab R6 Benutzerhandbuch

MAINTENANCE
●
Clean the filter screen in the clean water tank：
The filter screen in the clean water tank is used to filter impurities in water and scale generated
after boiling water, so please clean the filter screen in time after using it for several times to
ensure its filtering effect.
●
Removable hose：
The hose of this machine is detachable. If the hose breaks, please remove it and replace it
with a new one.
Hose elbow
13
Clean Water Tank
Latch
Hose connector

TROUBLESHOOTING

If any abnormality is found during use, please refer to the following table
Status Possible causes
The plug is not properly
connected and loose, resulting in
poor contact.
The machine does not
The internal line or power cord is
work after the switch
broken.
is turned on
The machine set overheats and
the protective device operates.
Nozzle blockage
The product does not
Water shortage in clean water tank
spray water
The internal water pipe is blocked
or broken
The suction port of the product is
blocked or large waste is inhaled
Abnormal noise
Motor failure
Too much dirty water in the dirty
water tank
Weak suction or no
Hose is broken
water absorption
Dirt blocking the suction
The ambient temperature is too ambient temperature (5°C-50°C）
Abnormal or
high or too low
inoperative machine
Slow heating of boiler
Hot water is not hot
The boiler is not heated
Processing method
Turn off the power and plug it
again.
Call the repair telephone.
Refer to the instructions for
protective device.
Remove the nozzle blockage
with a fine needle
Add water to the clean water
tank in time
Contact the merchant or
after-sales
Clear blockages in time
Contact the merchant or
after-sales
Clean the dirty water tank in time
Replace the hose with a new
one
Clear blockages in time
Keep the machine at a suitable
Contact the merchant or
after-sal e
Contact the merchant or
after-sales
14