cecotec PUMBA 2500 REFRESH SMART Bedienungsanleitung Seite 39

5. CLEANING AND MAINTENANCE
Important
1. Prevent the surface of the water fountain from deteriorating due to direct sun
exposure.
2. Do not clean the product with hot water.
3. It is recommended to use the same filter for only 30 days. Soak the new filter in water for
3 minutes before use.
4. As daily maintenance, clean the surface with a damp cloth.
5. It is recommended to clean the appliance at least once a week to reduce bacterial
growth.
6. It is recommended to change the water every 3-5 days in summer, and every 6-7 days in
winter.
The water pump has to be cleaned once a month to prevent it from clogging with
7.
limescale.
8. Do not use chemical products to clean the appliance, such as bleach or powder
detergent.
If you are not going to use the appliance for a long period of time, clean it and store it in
9.
a dry place.
Troubleshooting
Problem
The LED light does not switch
on and the pump does not
work
Red LED light
Blue LED light
Red LED light followed by
blue LED light
The UVC light does not switch
on
Possible cause
Bad USB cable connection.
Internal damage.
Minimum water level.
Need to replace the filter.
Minimum water level and
need to replace the filter.
Missing or incorrectly
positioned filter tray.
ENGLISH
Solution
Check that the fountain is
correctly connected to the
mains.
Contact Technical Support
Service.
Refill the fountain water until
the set values.
Replace the filter for a new
one.
Refill the fountain water
until the set values and then
replace the filter.
Check that the filter tray is
correctly positioned.
PUMBA 2500 REFRESH SMART
39