Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The occupation of the XLR-plugs is as follows:
PIN 1 = Shield
PIN 2 = Signal +
PIN 3 = Signal -
The occupation of the 6.35 jacks is as follows:
TIP = Signal -
RING = Signal +
SLEEVE = Shield
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Inserting/Replacing the battery
The enclosed remote control is operated with a CR2025 battery.
Please refer to the explanations under Operating Determinations.
Open the battery cover on the bottom and remove it.
If replacing the battery, remove the old battery from the battery compartment.
Only replace by the same type or similar types recommended by the manufacturer.
Remove empty battery in accordance with the instructions of the manufacturer.
Insert the battery and make sure that the poles are correct.
Replace the battery cover and close it.
OPERATION
Make sure to power-up before your power amplifier is turned in order to avoid loud transients which could
damage your speakers or annoy your audience.
Switch the device on via the power switch.
Program-section
This device features 8 programs for saving your settings (program numbers 1-8).
International
L
N
Danger of explosion when battery is replaced improperly.
Caution!
19/23
10356610_V_1_0.DOC
Werbung
Inhaltsverzeichnis
