Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Rearpanel
11
12
www.omnitronic.com
115 V
BALANCED INPUTS
2=SIGNAL
1=GND
230 V
3=SIGNAL
(11) AC CONNECTION
Plug the power supply cable in here.
POWER SWITCH Turns power to the equalizer on and off. Be sure to power-up before your power amplifier
is turned on to avoid loud transients which could damage your speakers or annoy your audience.
(12) AC VOLTAGE-SELECTOR
Make sure that the selector is properly set.
(13) MIDI IN- SOCKET
(14) Remote Control-socket
(15) Visual-connections
BGM: output sockets for background music. The DVP-36 automatically switched to background music, when
there is no signal input at Input 1 and 2 for 8 seconds.
(16) Subwoofer output socket
(17) Output R output socket
(18) Input level
(19) Input sockets R
XLR or TRS Input-sockets. Input 1 and 2 are treated the same way. The DVP-36 processes the signal from
the input with the first incoming signal (first come first served).
(20) Output L output socket
(21) Input level BGM
(22) Input sockets L
XLR or TRS Input-sockets.
INSTALLATION
Rack mounting
The voice processor is built for 19" racks/483mm. The minimum mounting depth is housing depth plus 100
mm for plugs and cables. The height is 44 mm only. You can fix the voice processor with four screws M6 in
the rack.
When mounting the voice processor into a rack, please make sure that there is a proper air circulation.
Please make sure that there is enough space around the device so that the heated air can be passed on.
The rack should be provided with a cooling fan.
Inputs
A good cable run improves the sound quality remarkably. Input cables should be short and direct, since high
frequencies will be mostly be absorbed if the cables are unnecessarily long. Besides that a longer cable may
lead to humming and noise trouble. If long cable runs are unavoidable, you should use balanced cables.
The inputs of your OMNITRONIC DVP-36 are equipped with XLR and ¼" jack-sockets.
Outputs
The high damping factor of your voice processor supplies a clear sound reproduction. Unnecessarily long
and thin cables will influence the damping factor and thus the low frequencies in a negative way. In order to
safeguard good sound quality, the damping factor should lie around 50.
The outputs of your OMNITRONIC DVP-36 are equipped with 6.35 jacks and XLR-connectors.
14
15
13
BGM
SIGNAL
GND
LINE
MIDI IN
2
1
OUT
VISUAL
REMOTE
16
17
18
IN 1/2
IN 1
SUB OUT
OUT R
LEVEL
+3 dB
IN 2
IN 1
IN 2
18/23
19
20
21
22
BGM IN
BGM
OUT L
LEVEL
+3 dB
IN 2
IN 1
INPUT L
INPUT R
10356610_V_1_0.DOC
BGM
Werbung
Inhaltsverzeichnis
